Troubleshooting

No picture

¥Display card should be completely seated in its slot.

¥Power Button and computer power switch should be in the ON position.

¥Signal cable should be completely connected to display card/computer and monitor.

¥Check connector for bent or pushed-in pins.

Image is scrolling or unstable

¥Signal cable should be completely attached to the computer and monitor.

¥Check pin assignments and signal timings of the monitor and your display card with respect to recommended timings and pin assignments.

¥If the Macintosh cable adapter is used, check for proper connection or make sure the display card is Macintosh compatible and that the card is properly seated in the computer.

LED on monitor is not lit (no green, orange color can be seen)

¥Power Switch should be in the ON position and power cord should be connected.

Picture is fuzzy or color looks blotchy

¥Adjust Brightness and Contrast Controls.

¥Access the Degauss Control through OSD controls. Activate the Degauss Control.

CAUTION: A minimum interval of 20 minutes should elapse before the Deguass Control is used a second time when not switching between modes.

Picture bounces or a wavy pattern is present in the picture

¥Move electrical devices that may be causing electrical interference away from the monitor.

¥See inside cover of UserÕs Manual for FCC information.

Edges of the display image are not square

¥Use the OSD Geometry Controls to straighten the edges.

¥If possible, position the front of the monitor facing east.

Display image is not centered, too small, or too large

¥ Use the OSD Size and Position Controls to adjust the image.

AS750Fmanualfinal.p65

11/11/03, 2:16 PM