NEC FE791SB, FE991SB user manual Quick Start, Figure A.1

Quick Start

To attach the MultiSync FE monitor to your system, follow these instructions:

1.Turn off the power to your computer.

2.If necessary, install the display card into your system. For more information, refer to the display card manual.

3.For the PC: Connect the 15-pin mini D-SUB of the captive signal cable to the connector of the display card in your system (Figure A.1). Tighten all screws.

For the Mac: Connect the MultiSync FE Macintosh cable adapter (not included) to the monitor connector on the Macintosh (Figure B.1). Attach the 15-pin mini D-SUB end of the captive signal cable to the MultiSync FE Macintosh cable adapter on the computer (Figure B.1). Tighten all screws.

4.Connect one end of the power cord to the MultiSync FE monitor and the other end to the power outlet (Figure C.1).

5.Turn on the monitor (Figure D.1) and the computer.

NOTE: If you have any problems, please refer to the Troubleshooting section of this User’s Manual.

Figure A.1 Figure B.1

15-pin mini D-SUB

Mac Adapter

(Not Included)

Captive Signal Cable Captive Signal Cable

MultiSync FE791SB / FE991SB 5

1-29