Verifying the
IP settings
Note: On Windows computers, click Start Programs Command Prompt.
Configuring for Pull Printing
6 Change the address by pressing Menu to increase or decrease each number. Press Select to move to the next segment. Press Select when you are finished.
The message Saved appears briefly.
7 Press Menu until you see Set IP Netmask, and then press Select.
8
9 Press Menu until you see Set IP Gateway, and then press Select.
10
11 When you are finished, press Go to return the printer to the Ready state.
1 Print another network setup page. Look under the “TCP/IP” heading and make sure the IP address, netmask, and gateway are what you want.
See “Printing a network setup page” on page 69 if you need help.
2 Ping the printer and verify that it responds. For example, at a command prompt on a network computer type “ping” followed by the new printer IP address:
ping xxx.xxx.xxx.xx
If the printer is active on the network, you will receive a reply.
If your printer has an optional ImageQuick firmware card installed, it can be configured for Pull Printing once an IP address has been assigned.
For detailed configuration instructions, refer to the CD that shipped with the ImageQuick card.
Configure for TCP/IP 71