Lexmark S510-2222-00 setup guide Installing a firmware card

Page 36

Installing a firmware card

4 Align the notches on the bottom of the card with the notches on the connector.

5 Push the memory card firmly into the connector until the latches on either end of the connector snap into place.

It may require some force to fully seat the card.

6 Make sure each latch fits over the notch on the end of the card.

Follow the instructions in this section to install a firmware card.

If you have a network internet model, an ImageQuick™ firmware card is already installed.

Note: Firmware cards designed for other printers may not work with your new printer.

If an option card has been installed, you need to remove the option card before installing the firmware card.

1 Remove the system board access cover (see page 24).

28 Install memory and option cards

Image 36
Contents Setup Guide Page Setup Guide Edition October Table of contents Index Introduction About your printerOther sources of information Publications CDSetup Guide Publications CD Quick Reference and sleeve Unpack your printerPaper size dial Considering environmental issues Select a location for your printerSelect a location for your printer Network and internet printers Select a location for your printer Printer with high-capacity feeder Set up the printer and paper handling options Topic Go toInstalling the printer base or cabinet Installing a 550-sheet drawer Positioning the printer Installing an optional duplex unit Set up the printer and paper handling options Set up the printer and paper handling options Installing an optional high-capacity feeder Attaching the docking frame Set up the printer and paper handling options Attaching the guide rail and feeder Set up the printer and paper handling options Set up the printer and paper handling options Installing height adjustment spacers Set up the printer and paper handling options Attaching the paper tray labels Install memory and option cards Removing the system board access coverScrews Use the following table to locate Installing a memory card Installing a firmware card Alignment pins System board holes Installing a hard disk Installing an option card Card FunctionInstall memory and option cards Install memory and option cards Reinstalling the system board access cover Attach cables Attach cablesAttach cables Local printing Install printer supplies Install printer suppliesRight top cover latch Install printer supplies Installing the photodevelopers Install printer supplies Install printer supplies Installing the toner cartridges Colored label Install printer supplies Attaching the Quick Reference booklet sleeve Attaching an adhesive operator panel overlay Closing the top cover Install printer supplies Load paper Well as for the multipurpose feederLoading the paper trays TraysLoad paper Load paper Load paper Load paper Using the heavy media tray Set the paper sizeSet the paper type Loading the multipurpose feeder Load paper Load paper Set button Loading the high- capacity feeder Load paper Load paper Load paper Verify printer setup Turning on the printerPrinting a menu settings Utilities MenuPrinting a network setup Configure for TCP/IP Setting the printer IP addressVerifying IP settings Configuring for Pull Printing Install printer drivers Network printingWindows Macintosh Supported printer driversInstallation instructions Other network environmentsInstall printer drivers Page Distribute information to users Identifying printer usersFinding information Distributing the information Storing the Quick CongratulationsIndex IndexIndex TCP/IP Page Readers’ Comments We’d Like to Hear from You Business Reply Mail Page Part Number 53P7114