Oki Telephony Adapter manual III Placing Calls, Via an IP network, General operation

Page 16

III Placing Calls

Via an IP network

Placing and receiving calls with the VoIP-TA unit are usually quite simple and performed in the same way as conventional telephone networks. In some cases however, the phone numbers to be used, may differ slightly from the ones you used previously.

General operation

Outgoing calls

Use a telephone that generates a Dual Tone Multiple Frequency (DTMF) signal. Pick up the handset and dial a remote party’s telephone number.

Incoming call response

An incoming tone will be emitted from the telephone.

Disconnection

A telephone call can be disconnected by hanging up the handset onto the telephone receiver.

8Placing Calls

Image 16

Contents User’s Guide VersionPage Page Page Contents Important Safety Instructions Important Safety Instructions Introduction Welcome to the world of Oki Internet telephony…Outline Features be usedVoIP-TA Front panel LANBack panel TELALARM-LED II Installation ConnectionsAnalogue telephone or G3 facsimile equipment Analogue PstnPower source Personal computer PCDuring installation During useVia an IP network III Placing CallsGeneral operation Services Third party incoming call during another callEnd-to-end service using Dtmf signaling Call transfer during a telephone callPlacing Calls Absent service How to register the absent serviceDetails of services Line selectionPlacing Calls For Pstn line not receiving services using hookflash hooking Using the IP network only IV Troubleshooting Symptom Items to checkSpecifications TEL portImportant Equipment Information Warranty period Warranty and ServiceFollowing the warranty period Oki Service Offices Head OfficeLondon Office Sydney Office3PP3507-4104P002