GE Daughter Card | Hardware Preparation and Installation |
| |
3.As shown in step 1 of the figure below, insert two plastic supports vertically in the holes used to fasten the GE daughter card.
4.As shown in step 2 of the figure below, at the back side of RTM-ATCA-7350, use a screwdriver to clockwise fasten the two screws used to fix the plastic supports.
5.Take the GE daughter card out of the antistatic package.
6.Insert the GE daughter card in RTM-ATCA-7350 by facing the daughter card at an angle of 45° to the RTM. Align the daughter card connector with the connector on RTM-ATCA-7350, and the daughter card positioning holes with the plastic supports on RTM-ATCA-7350. Exert even power downwards until the daughter card connector is fully inserted into the connector on RTM-ATCA-7350 and the daughter card is fastened by the plastic latches. See step 3 in the figure below.
Figure 2-4 Installing the GE Daughter Card
1
2
3
7.Insert RTM-ATCA-7350with the GE daughter card installed in the shelf. For more information refer, Installing RTM-ATCA-7350on page 30.
RTM-ATCA-7350 Installation and Use (6806800H30F) | 27 |