Hardware Preparation and Installation | Secondary PMCspan |
|
|
6.Gently press the PMCspan and MVME5500 together and verify that P4 is fully seated in J4.
7.Insert four short screws (Phillips type) through the holes at the corners of the PMCspan and into the standoffs on the MVME5500. Tighten screws securely.
1.8.3Secondary PMCspan
The
Personal Injury or Death
Dangerous voltages, capable of causing death, are present in this equipment. Use extreme caution when handling, testing and adjusting.
Product Damage
Inserting or removing modules with power applied may result in damage to module components.
Avoid touching areas of integrated circuitry, static discharge can damage these circuits.
Procedure
This procedure assumes that you have read the user’s manual that was furnished with the PMCspan, and that you have installed the selected PMC modules on your PMCspan according to the instructions provided in the PMCspan and PMC manuals.
1.Attach an ESD strap to your wrist. Attach the other end of the ESD strap to an electrical ground. Note that the system chassis may not be grounded if it is unplugged. The ESD strap must be secured to your wrist and to ground throughout the procedure.
2.Perform an operating system shutdown. Turn the AC or DC power off and remove the AC cord or DC power lines from the system. Remove chassis or system cover(s) as necessary for access to the VME module
3.If the Primary PMC Carrier Module and MVME5500 assembly is already installed in the VME chassis, carefully remove it as shown in Figure
4.Remove four screws (Phillips type) from the standoffs in each corner of the primary PCI expansion module.
32 | MVME55006E |