TOC | INDEX |
over the identifying mark. The Sensor Position Adjust tab has a guide in inches and milimeters that will help you identify where to set the tab to align the sensor over any identifying mark. To do this, simply measure from the cen- ter of the hole or mark to the edge of the label stock. For instance, if you have a 1/2 inch hole, which starts 1/4 inch from the edge of the label stock set the guide to 1/2 inch to make sure the sensor is in the middle of the through hole.
1” 1/2”
1” 1/2”
| Black Stripe |
|
| |||
2.5 | 2.0 | 1.5 | 1.0 | 0.5 | 0.0 | in. |
(63.5) | (50.8) | (38.1) | (25.4) | (12.7) | (0.0) (mm) | |
Sensor Position Adjustment
NOTE: If you are using black stripe sensing label material you will need to identify this in the printer driver under the Sensor Type setting. Please refer to section D later in this chapter for more information on changing driver settings.
12.Now your stock is installed. Please read the following section to install your cartridges.
12Supplies and Driver Settings