Primera Technology LX 810 user manual Sensor Type

Page 25

TOC

INDEX

Sensor Type

Sensor Type refers to the method the printer will use to center the print image on your label material. If you are using standard die-cut labels or Through-hole label material where a hole is punched through each label for alignment purposes use the Through-hole/Die-Cutsetting. Use Reflective for black stripe sensing label material where a pre-printed line indicates the break between labels. If you have continuous stock with no die-cut or reflective mark, set the sensor type to Continuous.

Rewinder Mode

This defaults to No. When set to no, the printer will align your labels with the tear off bar for easy removal. This mode can be set to Yes when using the printer with an automatic rewinder.

Enable Bi-di Printing

This setting defaults to Yes for fastest printing. When enabled you will be required to perform an alignment print after a new cartridge is installed. If you would like to bypass cartridge alignment set this setting to No and set the Cartridge Type set- ting to Color. You will now be able to skip the alignment print after changing cartridges.

TOF Offset

TOF stands for Top of Form and this setting allows you to fine tune the alignment of your printing on your label stock. This will be factory calibrated. If fine tuning is needed, increase this value to move the image down on the label. Decrease this value to move the image up the label. The unit of measure is 0.1mm.

Tear Off Offset

If Rewinder Mode (described earlier in this section) is set to No, the printer will present your labels over the Tear Bar for easy removal. This is set at the factory. If fine tuning is needed to align the break in your label stock over the Tear Bar, increase this setting to eject the label further; decrease this setting to eject the label stock less. The unit of measure is 0.1 mm.

Supplies and Driver Settings 21

Page 24 Page 26
Image 25
Page 24 Page 26
Contents 082206-510943-04 All rights reserved Printing History Table of Contents Interactive Feature in this Thank YOU… Getting StartedChoosing a Good Location Unpacking and Inspection Identifying the Parts Minimum MAC Specifications Minimum PC SpecificationsPC Installation Applying PowerTOC Index Mac Installation Ink Recommended Label Stock Supplies and Driver SettingsLabel Stock Compatibility Chart Installing Label Stock TOC Index Black Stripe If using a Mac If using a PCFor Macintosh and PC TOC Index To find Driver Settings on a PC Printer Driver SettingsTo find Driver Settings on a Mac Color Matching Following options are present in both the PC and Mac driversInk Saturation Clean/Purge Clean/Change Cartridges & Check Ink LevelsDetails/Print Counter Change CartridgesSensor Type Main Application Window Using the PrinterCreating a label TOC Index Text Tool Icon Text Cursor TOC TOC Index Graphics Tool Icon Graphics Cursor TOC Index Creating Barcodes in Nicelabel TOC Index RSS TOC Index Printing on a MAC from Adobe Illustrator TOC Index TOC Index TOC Index TOC Index Printing from Other Applications Creating Barcodes on a MACBasic Troubleshooting Cleaning the PrinterPause LED Technical SupportLabel Sensing Methods Method 1 Label Label SpecificationsRoll Specifications Print Speeds Technical SpecificationsLabel Design Pin Number Signal Description Auxiliary Port SpecificationsIndex Index
Top Page Image Contents