TOC | INDEX |
| b. If not, press the Unload button found on the front of |
| the printer simultaneously to reverse the stock out of |
| the print feed mechanism. Load a sheet of paper, not |
| to exceed 8.25 inches or 209 millimeters in width, into |
| the feed mechanism |
| by pulling the |
| Throat Guide all the |
| way out to make |
| room for the paper |
| then inserting a |
| sheet into the print |
| feed area. |
Once the sensor "sees" the paper it will automatically feed it into position and will begin to print.
c.The printer will print a purge pattern where swaths of each color are printed to clean the jets of the cartridge. A series of diagonal lines are printed in each color of both cartridges. By examining this pattern you can tell if the cartridge is firing all jets or if the cartridge is dirty and requires further cleaning. While the blocks of color may not print solidly, it is important that the diagonal lines be continuous. Repeat this process until all diagonal lines print without breaks.
Change Cartridge(s)
Click the Change Cartridge(s) button to move the cartridges into position for easy access for replacement. For more information on this see Section
Details/Print Counter
Clicking on the Details button will allow you to view informa- tion about printer settings stored on the printer. There is also a print counter in the details window to help you count the number of labels printed since the last time it was reset. Click Reset Counter to set the counter to zero. The Restore Factory Defaults button will restore the printer settings displayed on the details window to factory calibrated defaults.
20Supplies and Driver Settings