Philips ADM0101 Network Connections, Setting up Adim PC Connections, Allegiant Connections

Page 11

4

3

2

1

29

Input

 

 

 

 

 

 

ALLEGIANT Video Matrix

 

PHILIPS

 

Monitor Outputs

 

 

10 11

12 13

 

Figure 4.2

Figure 4.2 Shows the relationship of the Backup and Review DVRs and Allegiant outputs to the DVR Configuration page of the ADIM.

4.6Network Connections

•Interconnect the Serial Hub(s). ADIM PC, DVRs and network switches.

NOTE: Connect the ADIM PC to the Network using the port labeled LAN – Connect to Primary IP address.

Serial Hub

4.7 ADIM PC Connections

•Connect the Software Key to the parallel port of the PC.

4.8The PC is pre-configured with the following network parameters

•IP address: 10.10.0.10

•Subnet mask: 255.255.255.0

•Default Gateway: 10.10.0.1

Philips recommends that your IT department perform all network and set up configuration.

NOTE: The PC is pre-configured to communicate with

the Serial Hub that is shipped with ADIM. If a different Serial Hub is used with the system, the PC must be reconfigured. (Refer to the Serial Hub’s instruction manual.)

NOTE: A printer or other device can be connected onto the security key, but the key may not function properly unless the device is turned on.

4.9Setting up ADIM PC Connections

1.Connect the keyboard and mouse “Y” adapter to the mouse/keyboard port on back of PC. Connect the mouse and the keyboard to the “Y” adapter.

2.Connect the PC monitor to the port labeled

“PC Monitor Connector”. Plug the PC and Monitor power cords into the appropriate power sources, but do not turn on the power switches yet.

3.Connect the ADIM PC to Allegiant Console Port.

•Use the console cable to connect PC COM port number 1 to the Allegiant Console port.

•Make sure that the ADIM PC is configured for the same network segment as the Hi-Q Recorders [10.10.0.0/255.255. 255.0/10.10.0.1 (defaults)].

4.Connect the ADIM PC to the Network Switch.

5.Turn on the power switches to the PC and the monitor.

4.10 Allegiant Connections

•Connect the Allegiant to a PC COM Port 1 (recommended) using the supplied Console cable.

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Philips Communication Security & Imaging Installation InstructionsFCC & Ices Information Important SafeguardsSafety Precautions Securite Vorsicht SicherheitshinweiseseguridadVoorzichtig VeiligheidsmaatregelensicurezzaZasady Bespieczenstawa Medidas DE SegurançaTable of Contents System Overview Product DescriptionUnpacking Adim Adim Connections and Configuration Adim PC Connections PC is pre-configured with the following network parametersSetting up Adim PC Connections Network ConnectionsLogging on and User Levels Adim ConfigurationUser Level Default User Areas of Access Names Allegiant Document DVR ConfigurationOperation Explained Default Items from DVR ConfigurationOther Configuration Status and Monitoring Allegiant Camera Title Transfer Dialog Adim Keyboard Operation Problem Explanation / Resolution TroubleshootingEvent Error Info Component Component ID EntryAppendix a Event Logs Monitor Likely SourceMonitor Likely Source Log File Event Component Entry Error Info Component IDManual Alarm for Auxiliary Alarm forTo Event Only for To Continuous forTo Continuous with LTC 8506/00 Appendix B Technical SpecsAdim Components included Industrial PC MonitorAppendix D List of Compatible Dvrs Appendix C Recommended Network SwitchesAppendix E PRIMARY, BACKUP, and Review Dvrs Windows is a registered trademark of Microsoft Corporation
Top Page Image Contents