Philips 2.34E+07 user manual Remove the Base Assembly for Vesa Mounting

Page 11

2. Setting up the monitor

2.3Remove the Base Assembly for VESA Mounting

Before you start disassembling the monitor base, please follow the instructions below to avoid any possible damage or injury.

1.Place the monitor face down on a smooth surface. Pay attention not to scratch or damage the screen.

2. Remove the base.

1

2

3. Remove the hinge cover.

4. Lose four screws to remove the column.

Note

This monitor accepts a 100mm x 100mm VESA-Compliant mounting interface.

100mm

100mm

9

Image 11

Contents Customer care and warranty Troubleshooting & FAQs Table of Contents Operation Safety precautions and mainte- nanceNotational Descriptions Temperature 0-40C 32-95F Humidity 20-80% RHWaste Electrical and Electronic Equipment Disposal of product and packing materialInstall base stand Setting up the monitorInstallation Package contentsSetting up the monitor OFF Operating the monitorAdjust the OSD menu Change the signal input source Switch monitor’s power on and OFF Access the OSD menuReturn to previous OSD level Adjust the speaker volume Tilt Basic and simple instruction on the control keysOSD Menu Remove the Base Assembly for Vesa Mounting How does it work? how do I connect? What is it?MHL Mobile High-Definition Link introduction How do I use the MHL function?How does it work? Why do I need it?Image Optimization SmartImage LiteFirst launch -Wizard SmartContrastPhilips SmartControl Lite Start with Standard pane Adjust menu Color menu Image Optimization Image Optimization Exit Close SmartControl Lite Task Tray Menu DisabledContext Sensitive menu Convenience Technical SpecificationsPicture/Display ConnectivityStand PowerDimension WeightCabinet Operating ConditionEnvironmental Compliance and standardsFreq kHz Resolution Freq Hz Resolution & Preset ModesRecommended Resolution 1920x1080@60Hz digital input Power Management Definition Power ManagementFor more information, please visit Regulatory InformationLead-free Product Low energy consumption to minimize climate impactGS EK1-20002011 GS mark requirement Epeat Electronic Product EnvironmentalCommission Federale de la Communication FCC Declaration Federal Communications Commission FCC Notice U.S. OnlyRegulatory Infomation Nur original-Ersatzteile verwendet werden Paikka/IlmankiertoPlassering/Ventilasjon Bsmi Notice Taiwan Only Ergonomie Hinweis nur DeutschlandEU Energy Label China RoHSTypes of Pixel Defects Customer care and warrantyPhilips’ Flat Panel Monitors Pixel Defect Policy Pixels and Sub pixelsDark subpixel Black Dot DefectsProximity of Pixel Defects Total bright dot defects of all typesConsumer care number Price Customer Care & WarrantyCountry Country Call center Consumer care number Country Call centerConsumer care number AL Shahd Computer L.L.C Contact Information for Apmea regionSatisfactory, you can do manual adjustments via the OSD menu TroubleshootingImage appears distorted.Text is fuzzy or blurred SmartControl Lite FAQsGeneral FAQs Q10 Are Philips LCD monitors Plug-and- Play? Q7 How should I clean the LCD surface?Q3. I cannot hear sound from the monitor display Ans MHL FAQs