Samsung MAX-ZL65 Connecting your System to the Power Supply, Inserting Remote Control Batteries

Where to Install Your

Mini-Compact System

To take full advantage of your new mini-compact system, follow these installation instructions before connecting the unit.

Install the system on a flat, stable surface.

Never place this unit on carpeting.

Never place this unit in an outdoor area.

Maintain an open space of approximately 6 inches (15 cm) on the sides and rear of the system, for ventilation purposes.

Make sure that you have enough room to open the compact disc compartment easily.

Place the loudspeakers at a reasonable distance on either side of the system to ensure good stereo sound.

Direct the loudspeakers towards the listening area.

For optimum performance, make sure that both speakers are placed at an equal distance above the floor.

Inserting Remote Control Batteries

GB

Insert or replace remote control batteries when you:

Purchase the mini-compact system

Find that the remote control is no longer operating correctly

When replacing the batteries, use a new set of batteries and never mix alkaline and manganese batteries.

1	Place your thumb on the position marked	on the battery
	compartment cover (rear of the remote control) and push the cover in
	the direction of the arrow.
2	Insert two AAA, LR03 or equivalent batteries, taking care to respect
	the polarities:
	+ on the battery against + in the battery compartment
	– on the battery against – in the battery compartment
3	Replace the cover by sliding it back until it clicks into position.

-- Disc Selection / Direct Play --

Disc 1 Disc 2 Disc 3

On/Standby

Demo

PTY

RDS

Display

Timer /Clock

	Mono/ST	Preset/			Program	CD
		Memory				Repeat
			TUNER	CD
			Band
			D / P / S
	Deck 1/2	REV.Mode			Shuffle
			TAPE	AUX
Multi	F					Mul	t	Jog
	unction		CD	Dubbing			i
		REC/Pause	Synchro	Normal	HI - Speed

Disc Change

Volume

+

_

Power

Surround

S.BASS

E Q

Enter

D.S.P

Phones

If you will not be using the remote control for a long time, remove the batteries to prevent corrosion.

DownUp

CD–R/RW PLAYBACK

Tuning Mode

Connecting your System to the Power Supply

The main lead must be plugged into an appropriate socket.

Before plugging your system into a main socket, you must check the voltage.

1	Plug the main lead (marked AC Cord on the rear of the system) into
	an appropriate socket.
2	Press the On/Standby button to switch your mini-compact system on.

R

R

AUX

IN

7