Philips PXG20 Changing the Password, Selecting the Keylock Level, Checking the Lamp Usage Time

9. OTHER SETTINGS

4.Enter the new password using 3 / 4 to select the desired number, and then press 2 to select the next digit. Continue this procedure for the remaining three digits, and then press OK.

5.Enter the password again (‘Reconfirm’) using 1/2/3/4, and then press OK

6.To exit from the GUI, press Menu.

Note:

After setting the password, be sure to write it down in a secure location so as not to forget it.

Changing the Password

1.Follow steps 1 to 3 in ‘Setting the Password’ above.

2.Enter the old password using 1/2/3/4, and then press OK.

3.Enter the new password using 1/2/3/4, and then press OK.

4.Enter the password again (‘Reconfirm’) using 1/2/3/4, and then press OK.

5.To exit from the GUI, press Menu.

SELECTING THE KEYLOCK LEVEL

This function can be used to lock the use of certain operation buttons on the projector. The user can still operate the projector fully with the remote control.

Description of Keylock Levels

Normal:

All operation buttons are functioning. Level A:

Only Data 1, Data 2, Video, Volume, AV Mute buttons on the projector function.

Level B:

All operation buttons on the projector do not function.

1.Press Menu.

2.Press 1 / 2 to select ‘Options’.

3.Press 3 / 4 to select ‘Keylock Level’, and then press 2

4.Press 3 / 4 to select the desired level

5.To exit from the GUI, press Menu.

Notes:

–To cancel the keylock level, perform the above procedure using the remote control.

–If a password has been set and the keylock level selected, the password must be entered before adjusting the keylock level.

CHECKING THE LAMP USAGE TIME

This function allows you to check the accumulated lamp usage time.

1.Press Menu.

2.Press 1 / 2 to select ‘Options’. The lamp usage time will be displayed.

–It is recommended that the lamp be replaced after approximately 900 hours of usage. See page 29-30 for details.

Note:

After 1000 hrs of usage, the projector will not be able to turn on (it will go off if it is in use).

CHECKING THE INPUT SIGNAL

1.Press Menu.

2.Press 1 / 2 to select ‘Fine Sync’.

3.Press 3 / 4 to select ‘Signal Info’ to display the current input signal.

4.To exit from the GUI, press Menu.

SETTING A BACKGROUND IMAGE

This function allows you to select the image displayed when no signal is being sent to the projector.

Description of Background Images

Selected item	Background image
Philips	PHILIPS default image
Blue	Blue screen
None	Black screen

26