Philips CF-30FTSAZAM service manual Assembly of Palm Top Cover, Attach the Pad

■Assembly of Palm Top Cover

Using the pressure jig, Ensure the loads are applied equally.

Make sure the adhesive materials are attached closely on the whole side.

Process the speaker lead wire not to put inside when applying the load.

Avoid running over the protrusion attached to the protrusion side of the upper Cabinet.

Attach the Pad

A

B

Ensure that the PAD and the button neck are attached with adhesive firmly.

Insert FPC into the hole	Touch Pad SW Knob
of upper cabinet.	Rubber is set

	Order of fixing
	Screw	Screw	Screw
	Screw	Screw
	Note: Separation		Tighten of
			Screw
Touch Pad SW Knob			Tighten of
In is set			Screw

Notes for Separation

Tighten of

ScrewTighten of

Screw

Tighten of

Screw

Put to the arrow direction and attach it.

Protrusion

Attach the TP

Bottom Tape

Do not come over the Pad edge.

Attach the

PWB 6LED

Put to the left and set.

Palm Top Cover is set

Do not attach the oil on both sides. Avoid running over!

Attach the Pad WP Sheet

Attach within the range of the upper Cabinet concave.

Attach the Washer (See below)

LEDX6 Spacer	Insert FFC into the hole	Notes:
Sheet is set	of upper cabinet.
		After attaching, trace around TP,
FFC 6LED is set		SW and circumference with finger.

1. Apply the load when attaching the parts. 20N to 30N (2 to 3Kgf)/cm2

Palm Top

Cover

Attach the Washer

Attach it not to cover the hole of LEDX6 Spacer Sheet.

Palmtop Preparation

7-19