Philips SPB4230WA/17 manual

Page 18

PCB failure.You will have to call for service to replace the PCB.

What should I do if the alarm sounds continuously?

The alarm is alerting you that an overload situation is occurring. Immediately discon- nect a device from the UPS. If the alarm continues, disconnect another device, and so on until the alarm stops. Check the to- tal power requirements of your connected equipment and make sure it does not exceed the capacity of the UPS (1000V) before reconnecting.

18

Image 18
Contents Uninterruptible Power System UPS Page Table of contents Your UPS Congratulations on your purchase and welcome to PhilipsWhat’s in the box Electronics and computer systemProduct highlights What you’ll also needLCD message panel display flashing light indicates the UPS is in battery back-up modeUPS overview Front panel Digital clock Displays present timeGetting Started Connect your UPSConnect your UPS to a phone/ fax/modem Connect your UPS to a TV/VCR/ DVDR/cable box Using your UPS Check the power requirement of your equipmentTo connect coaxial cable protection Confirm all equipment connected to TipLow battery alarm Using more of your UPSBack-up alarm Auto restartDigital clock Warranty and ServiceLimited Lifetime Warranty StorageCalifornia Proposition 65 WARN- ING All Products Conditions and LimitationsThis connected equipment warranty is null and void if This warranty does not cover damage due to Warranty Claim ProcedureExclusions Technical data Noise level 40dBA 1 meter from surface UL-listed rating What should I do if the UPS back-up time is too short?Page