2-4 Basic Operation
This section explains the basic operation of XG1200.
2-4-1 Turning the XG1200 on
CAUTION
Do not move, shock, or vibrate the XG1200 while it is on.
1. Turn the power switch to the "on" position by pressing the [
] side.
The Power LED (Green) on the front of the XG1200 should turn on. The Alarm LED (Orange) should turn on for a moment, then should turn off. The Status LED (Green) should turn on. If an error occurs while the XG1200 is starting up, the Alarm LED (Orange) will start blinking.
2. When the system has finished starting up, the Status LED (Green) turns on.
If an error occurs after the startup stage has finished, the Alarm LED (Orange) will turn on.
2-4-2 Turning the XG1200 off
CAUTION
Should the XG1200 start giving off heat, smoke, and/or a strange smell, immediately disconnect the power plug from the power outlet. To make this easy, the XG1200 should be located close to the power outlet (wall socket or power strip), and the power outlet must be readily accessible.
Do not disconnect the ground cables before disconnecting the power power plug from the power outlet.
After the power is disconnected, contact the vendor's service department immedi- ately. Continued use of the XG1200 may cause an electric shock and fire.
Note that in this case, the state of data in transmission is not guaranteed.
1. Execute the system shutdown command.
If the firmware has not been updated yet, then execute system shutdown from the command line.
For details of the system shutdown dommand, refer to the "Command Reference" section in Refer the "XG1200 User's Guide".
2. Just turn the power switch to the "off" position by pressing the [
] side.
32
Installation and Operation