8
Technical data
Stacker relocation
The stacker must be moved by authorized personnel only.
In order to ensure that the stacker operates reliably after moving it to a new location, consider the following guidelines:
∙The new location must provide minimum clearances around the stacker. These clearances are shown in the diagram which is located in the Technical data section of this manual.
∙The flooring must be capable of supporting at least 100 lb. (45.5 kg) for the stacker and an additional 650 lb. (295 kg) for the attached printer.
∙The new location must be well ventilated and must maintain a consistent room temperature. Extreme temperature or humidity changes can affect the stacker.
∙Power source receptacles must be properly grounded.
Technical data
6SDFHUHTXLUHPHQWV
)ORRUVSDFHUHTXLUHPHQWV With printer: 122 inches x 117 inches (3101 mm x 2974 mm)
+HLJKWFOHDUDQFH 96 inches (2438 mm) from the floor to the nearest overhead obstruction, within the floor space requirements
0RYHDELOLW\ Once installed, the Stacker 1000 can be moved in order to access the printer media drawers.
Stacker 1000 Operator Manual Technical data