Xerox DocuPrint 96 manual Fuser agent

Page 34

Fuser agent

WARNING

If any fuser agent spills on the floor, remove it immediately. Fuser agent spills make the floor slippery. Use of Xerox Film Remover (isopropynal alcohol) is recommended to clean up spills.

CAUTION

The fuser reservoir has an anti-splash seal. Do not push the fuser agent bottle into the reservoir with excessive force, as this can damage the seal.

7.Replace the reservoir cap by turning it clockwise and push the fuser agent reservoir in until it stops.

8.Push the fuser drawer in until it latches in place.

3-4	Guide to Performing Routine Maintenance

Image 34

Contents Xerox DocuPrint 96/4635/180/2000 Series NPS/IPS Guide to Performing Routine Maintenance Table of contents Replacing the dry ink waste container Cleaning Maintenance and support servicesSafety Laser safetyOperation safety U. S Ozone information U. S. onlyOperation safety Europe Electrical supply Operator accessible areasVentilation Before cleaning your product MaintenanceCE mark Europe only Radio and telecommunications equipment directive Europe only For further information Safety Xii Guide to Performing Routine Maintenance Introduction ContentsAbout this guide Conventions Related publications Introduction Feeder trays Checking feeder traysGuidelines for loading paper Loading feeder traysAdditional guidelines for loading special stocks Loading trays 1 Page Do not load above the MAX line shown on the paper guide Loading trays 3, 4, 5, Page Page Page Feeder trays Guide to Performing Routine Maintenance Checking and unloading the sample tray Output trays and binsChecking and unloading purge trays Checking and unloading high-capacity stacker HCS bins Unloading a stacker binAlways use both hands to lift the paper stack out of the bin Page Fuser agent Fuser agent Put on gloves Page Fuser agent Page Fuser agent Guide to Performing Routine Maintenance Adding dry ink Page Page Guide to Performing Routine Maintenance Replacing the dry ink waste container Replacing the dry ink waste container Guide to Performing Routine Maintenance Page Cleaning Cleaning the sensors and the reflective surfaces Cleaning the Q850 sensor Page Cleaning the Q1011 sensor and mirror Page Cleaning additional sensors Sensor Q1107Q1106 and Q1166 Cleaning the 4mm cartridge tape drive Sensor Q1164Page Xerox Customer Service Center Maintenance and support servicesXerox Documentation and Software Services Xerox Font Center Operator trainingXerox Customer Education Reporting billing metersPage Index NumericsINDEX-2