Xerox DocuPrint 96 manual Guide to Performing Routine Maintenance

Page 43

Replacing the dry ink waste container

5.Discard the waste material and container according to the instructions on the label.

6.Slide a new, empty dry ink waste container into the printer until it stops.

NOTE: Do not remove the cap from the container.

7.Close the printer doors.

8.Dispose of the dropcloth.

CAUTION

If any dry ink gets on your hands, wash them with soap and cold water. Heat sets the ink permanently. If any dry ink gets on your clothes, brush them with a dry paper towel or a stiff-bristled brush. If this does not remove the ink, launder with detergent and cold water. Tell dry cleaners that the spot is dry ink for a printer so they do not use a solvent that sets the stain.

Guide to Performing Routine Maintenance

5-3

Image 43

Contents Xerox DocuPrint 96/4635/180/2000 Series NPS/IPS Guide to Performing Routine Maintenance Table of contents Maintenance and support services Replacing the dry ink waste container CleaningLaser safety SafetyOzone information U. S. only Operation safety U. SOperation safety Europe Electrical supply Operator accessible areasVentilation Before cleaning your product MaintenanceCE mark Europe only Radio and telecommunications equipment directive Europe only For further information Safety Xii Guide to Performing Routine Maintenance Introduction ContentsAbout this guide Conventions Related publications Introduction Checking feeder trays Feeder traysGuidelines for loading paper Loading feeder traysAdditional guidelines for loading special stocks Loading trays 1 Page Do not load above the MAX line shown on the paper guide Loading trays 3, 4, 5, Page Page Page Feeder trays Guide to Performing Routine Maintenance Checking and unloading the sample tray Output trays and binsChecking and unloading purge trays Unloading a stacker bin Checking and unloading high-capacity stacker HCS binsAlways use both hands to lift the paper stack out of the bin Page Fuser agent Fuser agent Put on gloves Page Fuser agent Page Fuser agent Guide to Performing Routine Maintenance Adding dry ink Page Page Guide to Performing Routine Maintenance Replacing the dry ink waste container Replacing the dry ink waste container Guide to Performing Routine Maintenance Page Cleaning Cleaning the sensors and the reflective surfaces Cleaning the Q850 sensor Page Cleaning the Q1011 sensor and mirror Page Sensor Q1107 Cleaning additional sensorsQ1106 and Q1166 Sensor Q1164 Cleaning the 4mm cartridge tape drivePage Xerox Customer Service Center Maintenance and support servicesXerox Documentation and Software Services Operator training Xerox Font CenterReporting billing meters Xerox Customer EducationPage Numerics IndexINDEX-2