dbx Pro 386 user manual Digital Applications A/D Conversion

Page 22

Section 3

386

Digital Applications

3.6 A/D Conversion

S/PDIF or AES/EBU

Rear Panel Connections

•Connect the source to the desired 1/4” TRS or XLR input.

•Connect the AES/EBU or S/PDIF output of the 386 and run into the AES/EBU or S/PDIF input interface of the DAW (CPU).

Front Panel Digital Output Features

1). Use the METER switch to select digital output metering.

2). Use the DITHER switch to select the desired dither algorithm.

3). Use the SHAPE switch to select the desired noise-shaping algorithm.

4). Use the SAMPLE RATE switch to select the correct sampling rate.

5). Use the WORD LENGTH switch to select the correct word length.

6). Use the OUTPUT FORMAT switch to select the appropriate digital output format.

®

14	386 User Manual

Image 22

Contents 386 Important Safety Instructions Declaration Conformity Table of Contents 386Intro Introduction DefiningIntroduction Service Contact Info WarrantyInstallation Recommendations Getting IEC Power Cord Receptacle Getting Started Rear Panel ConnectionsGetting Started Front Panel ControlsMeter Select Switch Front Panel Type IV conversion system controlsAnalog Basic Analog Connection Analog ApplicationsConnection to a Mixing Console Direct Connection to a Recorder Page Digital Digital Applications Digital Output Front Functions Digital Output Rear Panel ConnectionsDigital Applications Sync Input Sample Rate SelectionDirect Connection to a DAW CPU Rear Panel ConnectionsSection Direct Connection to a Digital MixerDigital Applications A/D Conversion Multi-Tracking to Digital Digital Applications Analog and Digital Output Application Appendix Sync Input Info Fig. A.1Block Diagram BlockBy Roger Johnson Type IV White PaperAppendix C Appendix C Appendix C Appendix C Appendix TruncationAppendix D Harman International Company