dbx Pro 386 user manual Multi-Tracking to Digital

Page 23

386		Digital Applications	Section 3

	3.7	Multi-Tracking to Digital

SYNC

AES/EBU or

S/PDIF

Rear Panel Connections

•Connect the source to the desired 1/4” TRS or XLR input jack.

•Connect the AES/EBU or S/PDIF output of the 386 and run into the AES/EBU or S/PDIF input of the digital mixer.

Front Panel Digital Output Features

1). Use the METER switch to select digital output metering.

2). Use the DITHER switch to select the desired dither algorithm.

3). Use the SHAPE switch to select the desired noise-shaping algorithm.

4). Use the SAMPLE RATE switch to select the correct sampling rate.

5). Use the WORD LENGTH switch to select the correct word length.

6). Use the OUTPUT FORMAT switch to select the appropriate digital output format.

®

386 User Manual	15

Image 23

Contents 386 Important Safety Instructions Declaration Conformity 386 Table of ContentsIntro Defining IntroductionWarranty Introduction Service Contact InfoInstallation Recommendations Getting Getting Started Rear Panel Connections IEC Power Cord ReceptacleFront Panel Controls Getting StartedFront Panel Type IV conversion system controls Meter Select SwitchAnalog Connection to a Mixing Console Analog ApplicationsBasic Analog Connection Direct Connection to a Recorder Page Digital Digital Output Rear Panel Connections Digital Applications Digital Output Front FunctionsSync Input Sample Rate Selection Digital ApplicationsRear Panel Connections Direct Connection to a DAW CPUDirect Connection to a Digital Mixer SectionDigital Applications A/D Conversion Multi-Tracking to Digital Digital Applications Analog and Digital Output Application Appendix Fig. A.1 Sync Input InfoBlock Block DiagramType IV White Paper By Roger JohnsonAppendix C Appendix C Appendix C Appendix C Truncation AppendixAppendix D Harman International Company