Belkin P72462 user manual Usage

Page 10

Usage

Selecting which computer to operate can be done either by pressing the SELECT button, or through keyboard hot-key commands. You will notice that after the OmniCube™ switches to another computer, the mouse will be inoperative for about 1-2 seconds. This is normal operation and ensures that proper mouse synchronization is established.

Pressing the SELECT button cycles you through ports 1 - 4.

OmniCube4-Port

1 2 3 4 Select

CONSOLE

F1D094

Keyboard Hot-Key commands:

To send commands to the OmniCube, the SCROLL LOCK key must be pressed twice within 2 seconds. You will hear a beep for confirmation. Below are the different commands:

Scroll

Scroll

1

Lock

Lock

Scroll

Scroll

3

Lock

Lock

Scroll

Scroll

 

Lock

Lock

 

Scroll

Scroll

0

Lock

Lock

:Switch to Port 1

:Switch to Port 3

:Switch to previous port

:Enables AutoScan mode.

Scroll

Scroll

2

Lock

Lock

Scroll

Scroll

4

Lock

Lock

Scroll

Scroll

 

Lock

Lock

 

:Switch to Port 2

:Switch to Port 4

:Switch to next port

In AutoScan mode, the OmniCuberemains on one port for 10 seconds before switching to the next. There is no mouse or keyboard control in this mode. This is necessary to prevent errors. Otherwise, if the user is moving the mouse or using the keyboard when the OmniCubeswitches to the next port, data flow is interrupted and will cause erratic mouse movement and/or the wrong characters to show up when using the keyboard.

To get out of AutoScan mode, hit the SPACEBAR.

10

Image 10
Contents OmniCube Introduction Features Technical Specifications Product Detail Front ViewMake sure you have the right cables Hardware Installation OmniCube F2N036-XX Usage Troubleshooting VideoTroubleshooting Information FCC/CE StatementBelkin Components