Belkin F1DS102P user manual Using Your KVM Switch, Powering Up the Systems

Page 12

P73778-C-SOHO-man-9_02.qxd 9/18/02 5:17 PM Page 20

INSTALLATION

9.Using the OmniView KVM Cable for SOHO Series with Audio (the KVM Cable), connect one end of the lime male 3.5mm plug to the speaker jack of your sound card or computer and connect the other end to the lime audio jack of the KVM Switch. See Fig. 14.

Fig. 14

10.Using the KVM Cable, connect one end of the pink male 3.5mm plug to the mic jack of your sound card or computer and connect the other end to the pink mic jack of the KVM Switch. See Fig. 14.

USING YOUR KVM SWITCH

Powering Up the Systems

Once all cables have been connected, power up the CPUs that are attached to the KVM Switch. All computers can be powered on simultaneously. The KVM Switch emulates a mouse and keyboard on each port and allows your computer to boot normally.

Your KVM Switch should now be ready for use.

You can select which computer to operate by either the direct-access port selectors located on the front panel of the KVM Switch or through keyboard hot key commands. Note that it will take 1–2 seconds for the video to display after switching. This is due to the refresh of the video signal. There is also re-synchronization of the mouse and keyboard signal that takes place. This is normal operation and ensures that proper synchronization is established.

Selecting a Computer Using Direct-Access Port Selectors

You can directly select which computer you wish to control by pressing the corresponding direct-access port selector next to the appropriate port. The LED will be lit to indicate that the port is currently selected.

Selecting a Computer Using Keyboard Hot Key Commands

You can command the KVM Switch to switch ports with a simple keyboard command sequence by using the “SCROLL LOCK” key and up/down arrow keys. To send commands to the KVM Switch, the “SCROLL LOCK” key must be pressed twice within two seconds. You will hear a beep for confirmation. Then you can press the up/down arrow keys to switch between ports.

Switch to next active port,

Switch to previous active port,

up arrow

down arrow

20

21

Page 11 Page 13
Image 12
Page 11 Page 13
Contents OmniView Table of Contents IntroductionFeature Overview OverviewEquipment Requirements Operating SystemsCables Unit Display Diagrams Front ViewBack View Overview Installation SpecificationsPre-Configuration Where to Place the KVM SwitchSingle-Switch Installation PS/2 Installation Keyboard, Video, and Mouse ConnectionsInstalling the KVM Switch Base Important NoteConnect the Computer Audio and Microphone Connections Connect the AudioUSB Installation Keyboard, Monitor, and Mouse ConnectionsConnect the Console Connect the Computer Using Your KVM Switch Powering Up the SystemsSelecting a Computer Using Direct-Access Port Selectors Selecting a Computer Using Keyboard Hot Key CommandsBelkin KVM Switches and Accessories AutoScan ModeOmniView KVM Switches OmniView E Series OmniView Soho Series with AudioOmniView PRO2 Series with On-Screen Display OmniView MATRIX2 Series with Dual-Console ControlOmniView KVM Cables OmniView E Series KVM CablesOmniView PRO Series Plus All-In-One KVM Cables OmniView Matrix Series All-In-One KVM CablesOmniView Gold Series All-In-One KVM Cables OmniView Daisy-Chain CablesFAQs OmniView KVM Accessories and AdaptersOr keyboard Troubleshooting Am getting a black screen on my monitorComputer boots up fine, but the mouse does not work USB F1DS102T, F1DS104T onlyWARRANTY, FCC, CE, Ices Statement Belkin Corporation Limited Five-Year Product WarrantyFCC Statement CE Declaration of Conformity
Top Page Image Contents