Belkin F1DS102P Single-Switch Installation, Important Note, Installing the KVM Switch Base

Page 7

P73778-C-SOHO-man-9_02.qxd 9/18/02 5:17 PM Page 10

INSTALLATION

Single-Switch Installation

This section provides complete instructions for the hardware setup of a single KVM Switch. (F1DS102P, F1DS104P, F1DS102T, or F1DS104T)

Important Note:

Before attempting to connect anything to the KVM Switch or into

your computer(s), make sure that everything is powered off. Plugging and unplugging cables while computers are powered on may cause irreversible damage to the computers and KVM Switch. Belkin Corporation will not be responsible for damage caused by these actions.

Installing the KVM Switch Base

Hold the main housing with one hand and the base with the other. With the narrow part of the base facing toward the rear of the housing, align the hooks of the base to the base holes located underneath the housing. Put the hooks through the holes and push the base toward the front of the housing to lock the base into place. See Fig. 3.

Fig. 3

INSTALLATION

PS/2 Installation

Keyboard, Video, and Mouse Connections

Connect the

Console

1. Using the cable that is included with your

monitor, connect it to the VGA port

in the “Console”

section of the KVM Switch. See Fig. 4.

2. Connect a PS/2 keyboard to the purple port in the “Console” section of the KVM Switch.

See Fig. 5.

Fig. 4

3.Connect a PS/2 mouse to the green port in the “Console” section of the KVM Switch. See Fig. 5.

Fig. 5

10

11

Image 7
Contents OmniView Introduction Table of ContentsOverview Feature OverviewOperating Systems Equipment RequirementsCables Front View Unit Display DiagramsBack View Where to Place the KVM Switch Overview InstallationSpecifications Pre-ConfigurationImportant Note Single-Switch InstallationPS/2 Installation Keyboard, Video, and Mouse Connections Installing the KVM Switch BaseConnect the Computer Connect the Audio Audio and Microphone ConnectionsKeyboard, Monitor, and Mouse Connections USB InstallationConnect the Console Connect the Computer Selecting a Computer Using Keyboard Hot Key Commands Using Your KVM SwitchPowering Up the Systems Selecting a Computer Using Direct-Access Port SelectorsOmniView Soho Series with Audio Belkin KVM Switches and AccessoriesAutoScan Mode OmniView KVM Switches OmniView E SeriesOmniView E Series KVM Cables OmniView PRO2 Series with On-Screen DisplayOmniView MATRIX2 Series with Dual-Console Control OmniView KVM CablesOmniView Daisy-Chain Cables OmniView PRO Series Plus All-In-One KVM CablesOmniView Matrix Series All-In-One KVM Cables OmniView Gold Series All-In-One KVM CablesOmniView KVM Accessories and Adapters FAQsOr keyboard Am getting a black screen on my monitor TroubleshootingUSB F1DS102T, F1DS104T only Computer boots up fine, but the mouse does not workCE Declaration of Conformity WARRANTY, FCC, CE, Ices StatementBelkin Corporation Limited Five-Year Product Warranty FCC Statement