English
TAPE
3a(for playback on tape deck 2 only)
•Press ’or ‘to select tape side (see Tape Side).
•Press A. REV to select the different type of playback mode (see Auto Reverse Playback).
4Press ‚to end playback.
ª"T1 or T2" with "! ! ! or @ @ @" will be displayed.
Note:
–When the tape has stopped playing, the system will switch to standby mode after 30 minutes if no button is pressed.
Rewind/Fast Forward
When playback is stopped
1You can rewind or fast forward the tape by pressing ˆor ‡respectively.
ªIf rewinding, "T1 ! or T2 !" with "!" scrolling left will be displayed.
ªIf fast forwarding, "T1 @ or
T2 @" with "@" scrolling right will be displayed
ªThe tape will stop automatically at the end of the rewinding or fast forwarding.
2Press ‚to stop rewinding or fast forwarding.
During playback
•Press and hold ˆor ‡until the desired passage is located.
ª"T1 or T2" with "! ! or @ @" scrolling left or right will be displayed depending on which button is pressed.
ªDuring searching, the sound is reduced to a low volume.
ªWhen you release ˆor ‡, the tape continues playing.
Notes:
–During rewinding or fast forwarding of a tape, it is also possible to select another source (e.g. CD, TUNER, or AUX).
–Before playing a tape, check and tighten slack tape with a pencil. Slack tape may get jammed or may burst in the mechanism.
–
–Store the tapes at room temperature and do not put them too close to a magnetic field (for example, a transformer, TV, or speaker).
Dolby B Noise Reduction System
1Press DOLBY B NR to switch on Dolby B NR.
ªThe d B NR appears in the display.
2Press DOLBY B NR again to switch off Dolby B NR.
ªThe d B NR disappears from the display.
Note:
–A tape recorded with the Dolby B NR system should also be played in the Dolby B NR mode. If you forget to operate the DOLBY B NR button, the treble may be reproduced too strongly.
.
24
pg | 24 | 3/6/00, 1:27 PM | 3139 116 19721 |