Philips P88 manual General Information, Environmental Information, Energy Star, Acknowledgement

Page 5

GENERAL INFORMATION

General Information

•The type plate (which contains the serial number) is located at the rear of the system.

•Recording is permissible if copyright or other rights of third parties are not infringed.

•This product complies with the radio interference requirements of the European Community.

Environmental Information

All unnecessary packaging has been omitted. We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet).

Your system consists of materials which can be recycled and reused if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packaging materials, exhausted batteries and old equipment.

Energy Star

As an ENERGY STARR Partner; Philips has determined that this product meets the ENERGY STARR guidelines for energy efficiency.

Acknowledgement

Dolby Pro Logic, Dolby B NR and the double-D symbol d are trademarks of Dolby Laboratories Licensing Corporation. Manufactured under license from Dolby Laboratories Licensing Corporation.

Accessories (Supplied)

–Remote control

–Batteries (two AA size) for remote control

–AM loop antenna

–FM wire antenna

–AC power cord

–CS-540 speaker package (includes one pair of surround speakers and one center speaker)

Safety Information

•Before operating the system, check that the operating voltage indicated on the typeplate (or the voltage indication beside the voltage selector) of your system is identical with the voltage of your local power supply. If not, please consult your dealer. The typeplate is located at the rear of your system.

•When the system is switched on, do not move it around.

•Place the system on a solid base (e.g. a cabinet).

•Place the system in a location with adequate ventilation to prevent internal heat build-up in your system. Allow at least 10 cm clearance from the rear and the top of the unit and 5 cm from the each side.

•The system incorporates a built-in safety feature that prevents overheating.

•Do not expose the system to excessive moisture, rain, sand or heat sources.

•Under no circumstances should you repair the system yourself, as this will invalidate the warranty!

SAFETY INFORMATION

•If the system is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lens of the CD unit inside the system. Should this occur, the CD player will not operate normally. Leave the power on for about one hour with no disc in the system until normal playback is possible.

•Electrostatic discharge may cause unexpected problems. See whether these problems disappear if you unplug the AC power cord and plug it in again after a few seconds.

•To disconnect the system from the power supply completely, remove the AC power plug from the wall socket.

English

5

pg 01-31/P88/22-Eng

5

3/6/00, 1:26 PM

3139 116 19721

Page 4 Page 6
Image 5
Page 4 Page 6
Contents 3139 116 Mini Hi-Fi SystemImportant notes for users in the U.K How to connect a plugMains plug Copyright in the U.KItaliano English Français Español Deutsch NederlandsSvenska DanskContents Safety Information Accessories SuppliedGeneral Information Environmental InformationPreparation FM Wire Antenna ConnectionAM Loop Antenna Connection Speakers ConnectionWireless Surround Out Connection Connecting other Equipment to your systemAC Power Supply Inserting batteries into the Remote ControlDolby PRO Logic Setting up the Dolby Pro Logic systemDolby Pro Logic Test ToneDolby 3 Stereo Dolby SurroundDolby Center Phantom Normal StereoDisc ControlsControls on the system and remote control ’, ‘, etc To stop the demonstration mode Demonstration modeEasy Set ModeSwitching the system to standby mode Switching the system onVolume Control Dim modeTo exit without storing the setting, press ‚ Personal SettingWOOx level cannot be stored as part of the personal setting Denotes the sound levelWhen normal wOOx sound effect is selected There are three wOOx settings to enhance the bass responseWOOx Automatic DSC-wOOx / VEC-wOOx selectionLoading the CD Changer CD TextDiscs for playback CD Direct PlayDisc Change Playing a CDSelecting a desired track Programming TracksErasing the program when Reviewing the programPlaying the program Storing Preset Stations Tuning to radio stationsTuning to Preset Radio Stations TunerOnly available in Radio Station with RDS NEWS/TA Traffic AnnouncementReceiving RDS Radio Station Tuner AUX/CDR There are two Auxiliary modes Normal AUX modeSelecting External Equipment During News bulletin or TrafficLoading a tape TapeTape Playback Auto Reverse Playback only onRewind/Fast Forward When playback is stoppedDolby B Noise Reduction System 3afor playback on tape deck 2 onlyRecording from other sources RecordingCD Synchro Start Recording Only Œ mode is available during dubbingOne Touch Recording Digital Recording via Digital OutClock Setting Timer SettingClock View ClockSleep Timer TimerTo switch off the Timer To switch off the Sleep TimerSubject to modification SpecificationsMaintenance Maintenance TroubleshootingCD Player Operation Radio ReceptionGeneral Tape Deck Operation
Top Page Image Contents