Too long is no good. | Twisted line is no good. | Install well. |
4、Refill Ink
Please pay attention to the ink level in the reservoirs; if the ink level is below 1CM as the picture shown above, please use refill kits to fill ink into Reservoir bottles. Carefully pull out the rubber plugs from the ink refill holes (There is possibility of ink spattering. Pls be careful.) Refill ink according to the colors. Then
5. Attention for Maintenance:
Take out the CISS including the inner cartridges and other components. Then remove support arm from printer, and
6. Notice:
1.Please don’t take out cartridge at random after installing the CIS system. Keep the reservoir bottles on the same level with the printer.
2.Try to keep at least 1/2 inch of ink in the bottles.
3.Don’t place the Reservoir Bottles too much higher or lower than the printer.
4.Suggested using in a dry place between 15 and 35 degree. Avoid exposure to direct sunlight.
5.Don’t reverse or lean the continuous ink supply systems during shipping. Please make sure all the ink filling holes and ventilation holes are closed tightly during transportation. Otherwise, the ink may leak.
6.Don’t sway the cartridge frequently. It may cause ink leakage.
7.Don’t pull out the connector of cartridge and don’t tear off adhesive tape at the bottom of cartridge.
7. Warning:
1.Not drinkable; keep it out reach of children.
2.Avoid exposure to direct sunshine and don’t keep it in high or freezing temperature.
3.Avoid collision and fallen down.
PDF 文件使用 "pdfFactory Pro" 试用版本创建 www.fineprint.cn