3M UMUV.10-045V2 user manual Loading the DOS Touchscreen Driver

AP-10AV / DP-10AV / DP-10AV Series User Manual

4. Using the System

D.Setup Touchscreen

For DOS (Cont.)

Loading the DOS Touchscreen Driver

After you install the files for the DOS touchscreen driver, you must load the driver before you can run a DOS touch application or open the DOS Touchscreen control panel.

You can run the DOS touchscreen driver from a full-screen DOS session within Windows. However, the Windows touchscreen driver cannot be running. Error message reads: “Windows x.x is running in 386 Enhanced mode. Device not found.”

This means either the Windows Touchscreen driver is loaded or the COM port/ IRQ designations are incorrect.

You can manually load the DOS touchscreen driver when needed, or you can let the system automatically load the driver when you start up your computer.

●To manually load the DOS touchscreen driver:

1.Close all applications and exit from Windows.

2.Access the DOS command line prompt.

3.Use the Change Directory (cd) command to switch to the directory that has the DOS touch driver files. By default, the Install program loads TouchWare into the C:\MTSTOUCH directory.

4.Type DOSTOUCH and then press Enter. The system displays a message that the driver is now installed. For example:

MicroTouch Mouse Emulator - Version x.x Copyright © 1990 - 1997 MicroTouch Systems, Inc.

Driver Installed

●To automatically load the DOS touchscreen driver when you start up your computer, add the following line to your AUTOEXEC.BAT file :

drive-designator :\directory\DOSTOUCH

where drive-designator and directory define the location (disk and path) of the files for the DOS touchscreen. For example:

Apr 05 P.18