SATO 400 manual Using the Printer, Printing a Self-Test Label

Page 14

CX400 User Guide

Label Edge and

Eye-Mark Sensor

Ribbon Sensor

Using the Printer

Printing a Self-Test Label

Printing a self-test label checks the printer overall operability. To run a self-test, confirm that the printer is loaded and connected to AC power and no print jobs are in process. Then:

1.Turn off the power.

2.Press and hold the FEED button.

3.Turn on the power.

4.After the printer starts printing release the FEED button.

5.After the self-test label finishes printing, the printer will enter the hex dump mode. To return to normal operation you must cycle printer power.

Important!

The printer will be in hex dump mode after printing the self- test label. It cannot print normal labels in hex dump mode. The printer will return to normal operation only when you cycle printer power.

Page 12

PN 9001107 Rev. A

Image 14
Contents CX400 Desktop Printer Operators Manual PN 9001107 Rev. a Table of Contents CX Software Media and SuppliesWhat You Get Controls, Indicators, and Connections Device Name Primary Function UseCX400 User Guide Printer Power Connection Printer Interface ConnectionCX400 User Guide Loading Labels or Tags Loading Ribbon CX400 User Guide Selecting the Label Sensor Type Sensor CalibrationUsing the Printer Printing a Self-Test LabelLabel Reprint Resetting the PrinterFeeding Blank Labels Sending Data to the PrinterPrinting Labels Routine MaintenanceControlling the Printer Using Direct Commands What To Do If … Error light is lit or flashing Common Problems And Their SolutionsPower light is not lit Host stops responding or displays printer not ready message Self-test label will not printLabel will not feed Labels feed continuouslyTechnical Support Poor print qualityPrinter Specifications CX400XM XB XL OCR-A/B Communication Ports Serial Input Cable DB9SParallel Input Cable Centronics 36 pin Serial Port ParametersCX400 Software Label Gallery FreeMedia and Supplies Windows Drivers
Related manuals
Manual 199 pages 39.12 Kb