SATO LM400E manual Ｌｉｎｅ key

Page 18

▲Operation Panel

Instructions and error messages are displayed in alphanumeric.

Display panel

Displays an error message and

instructions, etc.

ＬＩＮＥ key

Toggles the printer between on-line and off-line mode for print start/stop and for transmitting/receiving data.

ＦＥＥＤ key

Feeds the label.

Press once to feed one blank label.

*When turning the power ON, or when the label is not at the right position after setting the label, press the FEED key to adjust the label position.

DIP switch

Sets the operational parameters of printer

Adjustments

Can be used for adjustment when servicing.

Do not use this volume unless otherwise instructed. PRINT : Adjusting print darkness

OFFSET: Adjusting tear-off position

PITCH : Adjusting home position of the label

STATUS

Indicates the printer status.

Green: Enabled for print and data communication

Red: An error occurred.

Off: Disabled for print and data communication

8

Image 18

Contents LM400e Series 438A Alexandra Road #05-01/04 Alexandra Technopark Singapore Features of LM400e Series Safety Precautions Place the printer on a surface that is flat and level Do not expose the printer to liquids or moistureDo not insert foreign material into the printer Power cord Use only the designated electrical power and voltageConnect ground wire Case of drop or damageDo not use in locations with high humidity Power supplyDo not disassemble Carrying the printerReplacing fuse Setting labelsWhen unused for long periods of time CoverMaintenance and cleaning Table of Contents Precautions for installation and handling Keep the printer out of high temperature and humiditySelect a safe location Avoid dust Keep out of direct sunlightDo not place the printer near crane or pressing machine Power supply Connect the power cord to a grounded power outletUnpacking Accessories BoxNames of parts Label stopper Ｌｉｎｅ key Setting roll label Roll label Label stopper Label supply spindle Head lock lever Setting fan-fold label Label stopper Fan-fold label Slide guide Setting carbon ribbon Place an empty ribbon core on the ribbon take-up spindle Head lock lever Adjusting Pitch Sensor Turning on Power Connect the power cord and turn on the printerTurning the power on LM400e Series specifications Model LM408e / LM412e