SATO LM400E manual Place an empty ribbon core on the ribbon take-up spindle

4

Place an empty ribbon core on the ribbon take-up spindle.

Ribbon core

5

From the ribbon supply spindle, thread the carbon ribbon under the thermal head and to the ribbon take-up spindle.

Tape the free end of carbon ribbon to the ribbon core, and wind a few times in the direction of an arrow.

Be sure to confirm that the carbon ribbon is set as shown in the picture on the right.

Caution

Ribbon take-up spindle

Tape

*Thermal head and the surrounding areas will become hot during the printing process.

When changing the labels after printing, be careful not to get burnt. *Contacting the edge of thermal head with bare hands may result in injury. When changing the labels, be careful not to get injured.

16