TRENDnet TEG-S4000 manual Handling the Modules, Module Setup and Installation

Page 22

make sure that:

The 10Base-T twisted pair Ethernet cabling is Category 3 or above.

The 100Base-TX Fast Ethernet cabling is tested Category 5.

The 1000Base-T Gigabit Ethernet cabling is tested Category 5 enhanced.

The 100Base-FX fiber cabling is 62.5/125 micron multimode fiber, or 9/125 micro single-mode fiber.

The 1000Base-SX/LX fiber cabling is 50/125, 62.5/125 multi-mode or 9/125 micron single-mode fiber.

Chapter 4. Module Installation and

Removal

WARNING

Before installing the Modules into the 4-Slot Modular Switch, you must disconnect the Switch from the main power supply.

Handling the Modules

The Module can be easily damaged by electrostatic discharge. To prevent damage, please observe the following:

Do not remove Modules from their packaging until you are ready to install it into a Switch.

Do not touch any of the pins, connections or components on the Modules.

Handle the Modules only by its edges and front panel.

Always wear an anti-static wristband connected to a suitable grounding point.

Always store or transport Modules in appropriate anti-static packaging.

Module Setup and Installation

1.Ensure that the Switch is disconnected from the main power supply and that you are wearing an anti-static wrist-band connected to a suitable grounding point.

2.Place the Switch on a flat surface. Using a small cross-bladed screwdriver, remove the blanking plate

Image 22

Contents TEG-S4000 Copyright Statement Package Contents IntroductionFour Rubber feet Device Description, Features and Capabilities Slot Modular Switch Front and Rear PanelsPorts 10/100Base-TX Module Features Ports 10/100Base-TX ModulePage Ports 100Base-FX Fiber Module Port 100Base-FX Module Front ViewPorts 100Base-FX Fiber Module Features Port 100Base-FX Front ViewLocation and setting duplex mode Ports 100Base-FX Fiber Module Feature1000Base-SX/LX Fiber Module 1000Base-SX/LX Fiber Module Features1000Base-T Module Features 1000Base-T ModulePage 100Base-TX Fast Ethernet Network Guidelines Planning your Network10Base-T Ethernet Network Guidelines 100Base-FX Fast Ethernet Network GuidelinesNetwork Planning 1000BASE-SX /LX / TX Network GuidelineExpanded Networks 10Base-T Networks 100Base-TX NetworksCollapsed Backbone Link Expanding your 100Base-TX network Class100Base Solution Fileserver Link1000Base Solution Multi-port Bridge with High-Bandwidth BackboneUsed as a Multiport Bridge Installation Choosing a LocationConnecting the Switch Supplying PowerRack Installation Module Setup and Installation Handling the ModulesInstalling 100Base-FX Modules Installing the ModulesInstalling 10/100Base-TX Modules Installing 1000Base-SX/LX ModulesPower Input VoltageFrequency Appendix A. Technical SpecificationsInstalling 1000Base-T Modules Removing the ModulesPhysical Characteristics 1000Mbps indicator for 1000T module Power on/off indicator Appendix B. Pin Assignments Pin Pin Station Ports 1 ~ Cascade PortsSwitch Adapter Hub Technical Support