TRENDnet TEG-S4000 manual Installing the Modules, Installing 10/100Base-TX Modules

Page 23

from the rear of the Switch. Do not remove any other screws from the rear of the Switch.

3.Keep the blanking plate and screws in a safe place. If you remove the Module at any time, you must replace the blanking plate to prevent dust and debris from entering the Switch and to aid the circulation of cooling air.

4.Hold the Module so that the text on the front panel is oriented correctly, and insert it into the Switch, ensuring the connectors are fully engaged. Tighten the two captive thumbscrews that secure the Module in place.

Figure 4-1. Insert the module

Installing the Modules

Installing 10/100Base-TX Modules

a.Insert the RJ-45 connector on your cable into the socket of the Module.

b.Connect the other end of the cable to an appropriate device with a 100Mbps Fast Ethernet or 10Mbps Ethernet twisted pair interface.

c.Power up the Switch.

Installing 100Base-FX Modules

a.Remove the protective plastic covers from the fiber connectors on the Module.

b.Ensure that the Switch is powered up.

c.Plug the ST (or SC) connector on the fiber cable into the fiber socket on the Module.

d.Connect the other end of the fiber optic segment to an appropriate device fitted with a 100Mbps adapter.

Check the LED indicators on the front of the Switch to ensure that the Module is operating correctly.

Installing 1000Base-SX/LX Modules

Image 23
Contents TEG-S4000 Copyright Statement Introduction Package ContentsFour Rubber feet Slot Modular Switch Front and Rear Panels Device Description, Features and CapabilitiesPorts 10/100Base-TX Module Ports 10/100Base-TX Module FeaturesPage Port 100Base-FX Module Front View Ports 100Base-FX Fiber ModulePort 100Base-FX Front View Ports 100Base-FX Fiber Module FeaturesPorts 100Base-FX Fiber Module Feature Location and setting duplex mode1000Base-T Module 1000Base-SX/LX Fiber Module Features1000Base-T Module Features 1000Base-SX/LX Fiber ModulePage 100Base-FX Fast Ethernet Network Guidelines Planning your Network10Base-T Ethernet Network Guidelines 100Base-TX Fast Ethernet Network GuidelinesExpanded Networks 1000BASE-SX /LX / TX Network GuidelineNetwork Planning 100Base-TX Networks 10Base-T NetworksExpanding your 100Base-TX network Class Collapsed Backbone LinkFileserver Link 100Base SolutionMulti-port Bridge with High-Bandwidth Backbone 1000Base SolutionUsed as a Multiport Bridge Choosing a Location InstallationRack Installation Supplying PowerConnecting the Switch Handling the Modules Module Setup and InstallationInstalling 1000Base-SX/LX Modules Installing the ModulesInstalling 10/100Base-TX Modules Installing 100Base-FX ModulesRemoving the Modules Appendix A. Technical SpecificationsInstalling 1000Base-T Modules Power Input VoltageFrequencyPhysical Characteristics 1000Mbps indicator for 1000T module Power on/off indicator Pin Pin Station Ports 1 ~ Cascade Ports Appendix B. Pin AssignmentsTechnical Support Switch Adapter Hub