TRENDnet TEG-S4000 manual Ports 100Base-FX Fiber Module Features, Port 100Base-FX Front View

Page 9

2 ports 100Base-FX Fiber Module Features

Conforms to IEEE 802.3u Fast Ethernet standard

Support for SC or ST fiber connectors (optional)

Supports half and full duplex modes via DIP switches

Store-and-forward switch architecture for abnormal packet filtering

2 switching 100Mbps Fiber Ethernet ports

Back-plane up to 2.4Gbps

5 Mbytes Packet Buffer

Automatic address learning with 12K address entry storage

Filtering and forwarding rate of 148,800 packets per second

100Base-FX uses 62.5/125 micron multi-mode fiber or 8/125 micron single mode fiber for single mode type module.

4 Ports 100Base-FX Fiber Module

Figure 1-8. 4 port 100Base-FX Front View

When installed into a 4-Slot Modular Switch, this Module provides 4 x 100Mbps Fast Ethernet fiber ports which can be used to:

Connect the Switch to the backbone of your network; that is, to a basement switch, hub or router.

Connector the Switch to a 100Mbps server or end station.

An ST (or SC) connector provides the link to the multi-mode fiber cabling and three LEDs show five status of the Module at-a glance. A DIP-switch sets the operating mode to half duplex or full duplex (default).

Image 9

Contents TEG-S4000 Copyright Statement Introduction Package ContentsFour Rubber feet Slot Modular Switch Front and Rear Panels Device Description, Features and CapabilitiesPorts 10/100Base-TX Module Ports 10/100Base-TX Module FeaturesPage Port 100Base-FX Module Front View Ports 100Base-FX Fiber ModulePort 100Base-FX Front View Ports 100Base-FX Fiber Module FeaturesPorts 100Base-FX Fiber Module Feature Location and setting duplex mode1000Base-T Module Features 1000Base-SX/LX Fiber Module Features1000Base-SX/LX Fiber Module 1000Base-T ModulePage 10Base-T Ethernet Network Guidelines Planning your Network100Base-TX Fast Ethernet Network Guidelines 100Base-FX Fast Ethernet Network Guidelines1000BASE-SX /LX / TX Network Guideline Network PlanningExpanded Networks 100Base-TX Networks 10Base-T NetworksExpanding your 100Base-TX network Class Collapsed Backbone LinkFileserver Link 100Base SolutionMulti-port Bridge with High-Bandwidth Backbone 1000Base SolutionUsed as a Multiport Bridge Choosing a Location InstallationSupplying Power Connecting the SwitchRack Installation Handling the Modules Module Setup and InstallationInstalling 10/100Base-TX Modules Installing the ModulesInstalling 100Base-FX Modules Installing 1000Base-SX/LX ModulesInstalling 1000Base-T Modules Appendix A. Technical SpecificationsPower Input VoltageFrequency Removing the ModulesPhysical Characteristics 1000Mbps indicator for 1000T module Power on/off indicator Pin Pin Station Ports 1 ~ Cascade Ports Appendix B. Pin AssignmentsTechnical Support Switch Adapter Hub