TRENDnet TEG-S4000I manual Connecting the Switch, Diagnostic Test

Page 23

Diagnostic Test

After the installation is completed and AC power is applied to the switch, the system will automatically perform a diagnostic test. When the Power LED is on within 5 seconds, the Diagnostic status LEDs will soon flash red.

When the switch passes the self-test within 10 seconds, the Link/ACT LED turns on.

If the switch fails the self-test, the Diagnostic LED will blink.

Connecting the Switch

The serial console port is a male DB-9 connector that enables a connection to a PC or terminal for monitoring and configuring the switch.

Use the supplied RS-232 cable with a female DB-9 connector to connect a terminal or PC to the console port. The terminal or PC to be connected must support the terminal emulation program.

Figure 4-4.Connecting the MaxSwitch to a terminal

via RS-232 cable

23

Image 23

Contents Ethernet / Fast Ethernet / Gigabit Ethernet TEG-S4000iRelease Note Slot modular switch manualVlan Setting Internet Explorer SettingIntroduction Key Features Console and Telnet Management Intelligent Module FeaturesManagement Methods Snmp Network Management Web-based ManagementPackage Contents Front & Rear Panel Physical DescriptionLK/ACT LED IndicatorsSpanning Tree Software ConceptsRS-232 Console Static AddressPort Trunking Virtual LANs VLANsBroadcast Storm Filter Port MirrorPort Security PriorityCollapsed Backbone Application Collapsed Backbone Application Departmental BridgeDepartmental Bridge Application Port-based Vlan Workgroup Ieee 802.1Q Vlan ApplicationShared Server Pre-Installation Requirements Connecting to the Network Desktop Installation Mounting the Switch4. Attach mounting brackets with screws Rack MountingPower On Diagnostic Test Connecting the SwitchSetting of communication parameters Assigning IP Address Device SettingsPort Setting Page Address table Igmp Vlan Mode 2 modes Vlan For Cpu2 VLANs Secure IP for Telnet and Http About Web-based Management System LoginSystem Configuration Home Modules ModulesPorts Ports1 The Statistics Statistics2 The Statistics Vlan Virtual LAN Vlan TrunkTrunk STP Spanning Tree Protocol1 The STP upper Page 1 The STP lower Type the number in the Max Allowed MAC Address Count Programmable Mapping of 802.1p to Internal Priority Priority Igmp IP Multicast 11. Port Priority Type of ServiceStatic Address 13 The Static Address 15 The Port Mirror IP Config 16 The IP Config Save Save and RebootReboot UpgradeSnmp Management Operation Description Snmp ManagementProduct Specifications Compliance EMI Appendix a Internet Explorer Setting Click sites Level Page Port-Based Vlan MaxSwitch II MPage Tagging Mac Address based Vlan MaxSwitch II MPage Page Registration Problem ReportHardware Repair Service Technical Support