•• ! • • • • • • •
The Install program will automatically add a line to your CONFIG.SYS file using the following syntax and format:
DEVICE=[path_name]CARDGO.EXE [/IRQ=xx] [/IO=xxx][/MEM=xxxx][/?]
where
[/IRQ=xx] | Specifies the hardware interrupt of your card. Default |
| value is 5. |
| Valid IRQs are 3, 4, 5, ,9, 10, and 11. |
[/IO=xxx] | Specifies the I/O address. Default value is 300. |
| Valid port addresses are 300, 320, 340, 360, 240, and |
| 280. |
[/MEM=xxxx] | Specifies the memory address. Default value is |
| D400H. |
| Valid memory addresses are D000H, D400H, D800H, |
| and DC00H. |
[/?] | Displays all possible command syntax. |
You can also run CARDGO.EXE by typing “CARDGO” at the D O S p r o m p t o r b y i n c l u d i n g i t a s a l i n e i n y o u r AUTOEXEC.BAT file.
After you executed CARDGO.EXE, you will see a display similar to the following indicating that the installation was successful:
Socket | : | 0 |
IRQ Number | : | 05 |
I/O PORT Base | : | 300H |
MEM Base | : | D000H |
The list of error messages the client driver may display and the correction methods suggested are given in Appendix B.
! 23