Star Micronics TSP100 manual Connecting the Power Cord

Page 14

3-6. Connecting the Power Cord

Note: Before connecting/disconnecting the power cord, make sure that power to the printer and all the devices connected to the printer is turned off. Also make sure the power cable plug is disconnected from the AC outlet.

(1)Check the label on the back or bottom of the printer to make sure its voltage matches that of the AC outlet. Also make sure the plug on the power cord matches the AC outlet.

(2)If the power cord is not attached to the printer, plug the appropriate end into the AC inlet on the back of the printer.

(3)Plug the power cord into a properly grounded AC outlet.

CAUTION

If the voltage shown on the label on the of your printer does not match the voltage for your area, contact your dealer immediately.

– 11 –

Image 14
Contents Hardware Manual EC Council Directive 89/336/EEC of 3 May Table of Contents Unpacking and Installation UnpackingParts Identification and Nomenclature Auto Cutter ModelTear Bar Model Choosing a place for the printer Setup Connecting the USB Cable to the PrinterConnecting to a Peripheral Unit Loading the Roll Paper Tear Bar Model Page Connecting the USB Cable to the PC Installing the Printer SoftwareConnecting the Power Cord Turning Power On Attaching the Accessories Attaching the Holder PlateAttaching the Rubber Feet Switch Blind Installation Termal Roll Paper Specification Core outer Core innerControl Panel ErrorsControl Panel and Other Functions Non-recoverable errors Self-Printing Removing Paper Jam Preventing and Clearing Paper JamsPreventing Paper Jams Releasing a Locked Cutter Auto Cutter Mode only Page Cleaning the Paper Holder Periodical CleaningCleaning the Thermal Head Drive circuit Peripheral Drive ConnectorPeriheral Unit Drive Circuit Page Specifications General SpecificationsInterface Auto Cutter SpecificationsElectrical Characteristics Environmental RequirementsReliability Overseas Subsidiary Companies Star Micronics AMERICA, INC