Star Micronics TSP100 manual Releasing a Locked Cutter Auto Cutter Mode only

Page 24

7-3. Releasing a Locked Cutter (Auto Cutter Mode only)

If the auto cutter locks up or fails to cut the paper, follow the steps below.

WARNING

Since working on the cutter may be dangerous, be sure to turn off the printer first.

(1)Set the power switch to OFF to turn off the printer.

(2)Remove the front cover to reveal the auto cutter.

(3)Remove any jammed paper.

Note: Be careful not to damage the printer while removing any jammed paper.

Since the thermal print head is particularly sensitive, be sure not to touch it.

Front cover

Auto cutter

– 21 –

Image 24
Contents Hardware Manual EC Council Directive 89/336/EEC of 3 May Table of Contents Unpacking and Installation UnpackingParts Identification and Nomenclature Auto Cutter ModelTear Bar Model Choosing a place for the printer Setup Connecting the USB Cable to the PrinterConnecting to a Peripheral Unit Loading the Roll Paper Tear Bar Model Page Connecting the USB Cable to the PC Installing the Printer SoftwareConnecting the Power Cord Turning Power On Attaching the Accessories Attaching the Holder PlateAttaching the Rubber Feet Switch Blind Installation Termal Roll Paper Specification Core outer Core innerErrors Control Panel and Other FunctionsControl Panel Non-recoverable errors Self-Printing Preventing and Clearing Paper Jams Preventing Paper JamsRemoving Paper Jam Releasing a Locked Cutter Auto Cutter Mode only Page Periodical Cleaning Cleaning the Thermal HeadCleaning the Paper Holder Peripheral Drive Connector Periheral Unit Drive CircuitDrive circuit Page Specifications General SpecificationsAuto Cutter Specifications Electrical CharacteristicsInterface Environmental RequirementsReliability Overseas Subsidiary Companies Star Micronics AMERICA, INC