Star Micronics TSP100 manual Setup, Connecting the USB Cable to the Printer

Page 8

3. Setup

3-1. Connecting the USB Cable to the Printer

Affix the ferrite core onto the USB interface cable and pass the cable through the cable support as shown. Then, connect the USB interface cable to the printer.

Note: The dialog shown below may appear on your PC screen if your PC is running Windows 98 or Me, and if you turn ON the power of the printer for the first time while the PC and the printer are connected with the USB cable. In this case, refer to the software manual on the CD-ROM, in the following directory: Documents folder.

– 5 –

Image 8

Contents Hardware Manual EC Council Directive 89/336/EEC of 3 May Table of Contents Unpacking and Installation UnpackingParts Identification and Nomenclature Auto Cutter ModelTear Bar Model Choosing a place for the printer Setup Connecting the USB Cable to the PrinterConnecting to a Peripheral Unit Loading the Roll Paper Tear Bar Model Page Connecting the USB Cable to the PC Installing the Printer SoftwareConnecting the Power Cord Turning Power On Attaching the Accessories Attaching the Holder PlateAttaching the Rubber Feet Switch Blind Installation Termal Roll Paper Specification Core outer Core innerControl Panel ErrorsControl Panel and Other Functions Non-recoverable errors Self-Printing Removing Paper Jam Preventing and Clearing Paper JamsPreventing Paper Jams Releasing a Locked Cutter Auto Cutter Mode only Page Cleaning the Paper Holder Periodical CleaningCleaning the Thermal Head Drive circuit Peripheral Drive ConnectorPeriheral Unit Drive Circuit Page Specifications General SpecificationsAuto Cutter Specifications Electrical CharacteristicsInterface Environmental RequirementsReliability Overseas Subsidiary Companies Star Micronics AMERICA, INC