Multi-part mode
When the printer is in the Multi-part Mode, the print head prints with greater impact. It should be noted, however, that printing in the Multi- part Mode also reduces the life of the print head. Because of this, you should use the Multi-part Mode only for printing on four or five-ply paper. Use the Normal Mode for printing on one to three-ply paper. When Auto (SW2: ON, SW3: ON) is selected, the printer automatically switches between the Multi-part Mode and Normal Mode according to the adjustment lever position. The Normal Mode is automatically se- lected when the adjustment lever is at any setting of 3 or less, while the Multi-paper mode is selected for settings greater than 3.
Waiting period for Paper loading
This function sets the amount of wait time between paper insertion and paper feeding. If the paper feeds before you can adjust the paper position to your satisfaction, increase the wait time.
75% Compress mode
In the compression mode, the printer is able to receive print data for up to 10.6-inch printing width. The print data is compressed from 10.6 inches to 8 inches (compression ratio of 75%).
FF command / Eject direction
These functions are valid when the release lever is set to the cut-sheet paper position.
Eject paper at Power ON
This function is valid when the release lever is set to the cut-sheet paper position. This function selects whether to eject the cut-sheet paper when a cut-sheet paper is on the paper guide at power on.
Skip over perforation
This function is valid only when fanfold paper is selected. When enabled, the printer provides a one-inch margin between the last line printed on one page and the first line printed on the next page.