Star Micronics LC-1021 user manual Printed on Return is enabled

54 Optional Accessories

Problem	Possible Cause	Recommended Action
Incorrect number of lines are	Auto line feed with carriage	Use the EDS Mode to
printed on the page.	return is enabled.	disable auto line feed with
		carriage return. See “Switch
		4: Auto LF with CR” on
		page 32 .
	The line spacing or leading	Choose a different line
	selected by your application	spacing or leading setting
	program is wrong.	from your application.
	Dot adjustment is not	See “Adjusting the dot
	correct.	alignment” on page 51.
Text and graphics are	The ribbon is worn out or	Replace the ribbon with a
malformed.	“used up.”	new one.
Print quality is poor.
	The printer is not set up	Set up the printer for the
	correctly for the thickness of	paper thickness you are
	paper being used.	using. See “Adjusting for
		paper thickness” on
		page 42.
	The printer is not in the Multi-	Use the EDS Mode to enter
	part Mode when printing on	the Multi-part Mode. See
	multi-part forms with an	“Switch 6: Multi-Part Mode”
	original and three to four	on page 32.
	copies.
	The print head is damaged.	Return the printer to your
		dealer for repair.
Forms are smudged.	The printer is not set up	Set up the printer for the
	correctly for the thickness of	paper thickness you are
Printing is too dark.	paper being used.	using. See “Adjusting for
		paper thickness” on
		page 42.
	The ribbon is jammed,	Make sure that the ribbon
	twisted, or not set correctly	cassette is installed
	between the print head and	correctly. See “Installing the
	the print head shield.	ribbon cassette” on page 6.
	Print head shield is damaged	Return it to your dealer for
	or missing.	repair.