TRENDnet TEW-310APBX manual Resetting the TEW-310APB to Factory Default Settings

Page 25

4. Resetting the TEW-310APB to Factory Default Settings

4. Resetting the TEW-310APB to Factory Default Settings

After you have tried other methods for troubleshooting your network, you may choose to Reset the TEW-310APB to the factory default settings. Remember that TRENDnet wireless products network together, out of the box, at the factory default settings.

To hard-reset the TRENDnet TEW-310APB to Factory Default Settings, please do the following:

∙Locate the Reset button on the back of the TEW-310APB (next to the Ethernet port).

∙Use a paper clip to press the Reset button.

∙Hold for about 5 seconds and then release

∙After the TEW-310APB reboots (this may take a minute) it will be reset to the factory Default settings.

24

Image 25

Contents TEW-310APB TEW-310APBX 2.4 GHz Wireless Access Point + BridgeUsers Guide 1.Package Contents CONTENTS3.Wireless Basics 5.Using the Configuration Utility2 Locate antenna connectors Replacing the antenna with high gain antenna1 Locate the two antennas inside the boxContents 1. Package ContentsSystem Requirements If any of the above items are missing, please contact your resellerConnections 2. IntroductionFeatures and Benefits LED Indicators 3. Wireless Basics Installation Considerations TRENDware Wireless Family of LAN products includeStandards - Based Technology objects that the wireless signal must pass thru may limit range. Typical ranges vary depending on the types of materials and any background RF radio frequency noise in your home or business. The key to maximizing range is to follow these basic guidelines please remember that the IP Address for each computer must be in 4. Getting StartedIP ADDRESS Setting Up an Infrastructure Network Factory Default Setting for the TEW-310APB 5. Using the Configuration MenuConfiguration Menu Status Screen with Menu Bar AP name SSID Channel WEP Key Mode Basic SettingsAutomatically . Or you can IP SettingsSubnet Mask , and Gateway by AP Mode Advanced SettingsAuthentication Type 802.1X SecurityTools Note Please do not interrupt the firmware upgrade processBased on Windows XP Operating System 6. TroubleshootingGateway Address ∙ Select the Hardware Tab ∙ Click Device Manager ∙ Click PropertiesCardbus Adapter Adapters∙ Right-click on 22M Wireless ∙ Select Properties to check that the drivers are installed properly4. Resetting the TEW-310APB to Factory Default Settings Select Set up a home or small office network Using the Network Setup Wizard in Windows XP7. Networking Basics Microsoft Windows XP Go to Start Control Panel Network ConnectionsClick Next Please follow all the instructions in this windowWorkgroup name Enter a Computer description and a Computer nameClick Next Note Each computer should have a unique Computer name Please wait while the wizard applies the changes When the changes are complete, click NextFormat the disk if you wish, and click Next Insert a disk into the Floppy Disk Drive, in this case drive APlease wait while the wizard copies the files Page In Windows XP Naming your ComputerChecking the IP Address in Windows XP/2000 Go to Start All Programs Accessories Command PromptAddress Type Command and click OKControl Panel Assigning a Static IP AddressNetwork Connections ∙ Right-click on Local Area Connections ∙ Click Properties∙ Highlight Internet Protocol TCP/IP You have completed the assignment of a Static IP Address ∙ Input your DNS server address only if you plan to use the InternetNetwork Connection Connecting to a Wireless Network in Windows XPInternet Protocol TCP/IP click Properties ∙ Select Obtain an IP address∙ IP address ∙ Subnet mask Connecting to a Wireless Network in WindowsProperties select Internet Protocol TCP/IP click Properties Connecting to a Wireless Network with a Wireless Router or an Access Point using a DHCP server in Windows ∙ Go to Start Settings Control Panel Double-click Connecting to a Wireless Network in Windows Me andselect Internet Protocol TCP/IP click Properties ∙ Select Detect connection to network media∙ Select Specify an IP address Checking the Wireless Connection by PingingFor Windows XP and Shared Documents folder and Sharing files and folders in the Help and For Windows Me andFile and Printer Sharing Diagnostic LED 8. Technical SpecificationsStandards PortsWeight DimensionsTemperature HumidityTRENDware Technical Support over the Telephone Tel +1-310-891-1100 9. Contacting Technical SupportTRENDware Technical Support E-mailAddress E-mail support@trendware.com