TRENDnet TEW-310APBX manual ∙ Input your DNS server address only if you plan to use the Internet

Page 38

∙Input your DNS server address only if you plan to use the Internet.

∙Select Use the following IP address in the Internet Protocol (TCP/IP) Properties window,

∙Input your IP address and subnet mask. (The IP Addresses on your network must be within the same range. For example, if one computer has an IP Address of 192.168.0.2, the other computers should have IP Addresses that are between 192.168.0.3 and 192.168.0.254. No two computes can have the same IP Address. The subnet mask must be the same for all the computers on the network.)

∙Input your DNS server address only if you plan to use the Internet.

(Note: If you are entering a DNS server address, you must also enter the IP Address of the Default Gateway.)

The DNS server information will be provided by your ISP (Internet Service Provider.)

Fig. 7.25

∙Click OK

You have completed the assignment of a Static IP Address.

37

Image 38

Contents Users Guide 2.4 GHz Wireless Access Point + BridgeTEW-310APB TEW-310APBX 3.Wireless Basics CONTENTS1.Package Contents 5.Using the Configuration Utility1 Locate the two antennas Replacing the antenna with high gain antenna2 Locate antenna connectors inside the boxSystem Requirements 1. Package ContentsContents If any of the above items are missing, please contact your reseller2. Introduction ConnectionsFeatures and Benefits LED Indicators 3. Wireless Basics Standards - Based Technology TRENDware Wireless Family of LAN products includeInstallation Considerations objects that the wireless signal must pass thru may limit range. Typical ranges vary depending on the types of materials and any background RF radio frequency noise in your home or business. The key to maximizing range is to follow these basic guidelines IP ADDRESS 4. Getting Startedplease remember that the IP Address for each computer must be in Setting Up an Infrastructure Network Configuration Menu 5. Using the Configuration MenuFactory Default Setting for the TEW-310APB Status Screen with Menu Bar Basic Settings AP name SSID Channel WEP Key ModeSubnet Mask , and Gateway by IP SettingsAutomatically . Or you can Advanced Settings AP ModeAuthentication Type Security 802.1XNote Please do not interrupt the firmware upgrade process Tools6. Troubleshooting Based on Windows XP Operating SystemGateway Address ∙ Click Properties ∙ Select the Hardware Tab ∙ Click Device Manager∙ Right-click on 22M Wireless AdaptersCardbus Adapter ∙ Select Properties to check that the drivers are installed properly4. Resetting the TEW-310APB to Factory Default Settings 7. Networking Basics Using the Network Setup Wizard in Windows XPSelect Set up a home or small office network Microsoft Windows XP Go to Start Control Panel Network ConnectionsPlease follow all the instructions in this window Click NextClick Next Note Each computer should have a unique Computer name Enter a Computer description and a Computer nameWorkgroup name When the changes are complete, click Next Please wait while the wizard applies the changesInsert a disk into the Floppy Disk Drive, in this case drive A Format the disk if you wish, and click NextPlease wait while the wizard copies the files Page Naming your Computer In Windows XPGo to Start All Programs Accessories Command Prompt Checking the IP Address in Windows XP/2000Type Command and click OK AddressNetwork Connections Assigning a Static IP AddressControl Panel ∙ Highlight Internet Protocol TCP/IP Connections ∙ Click Properties∙ Right-click on Local Area ∙ Input your DNS server address only if you plan to use the Internet You have completed the assignment of a Static IP AddressInternet Protocol TCP/IP click Properties Connecting to a Wireless Network in Windows XPNetwork Connection ∙ Select Obtain an IP addressProperties select Internet Protocol TCP/IP click Properties Connecting to a Wireless Network in Windows∙ IP address ∙ Subnet mask Connecting to a Wireless Network with a Wireless Router or an Access Point using a DHCP server in Windows select Internet Protocol TCP/IP click Properties Connecting to a Wireless Network in Windows Me and∙ Go to Start Settings Control Panel Double-click ∙ Select Detect connection to network mediaFor Windows XP and Checking the Wireless Connection by Pinging∙ Select Specify an IP address File and Printer Sharing For Windows Me andShared Documents folder and Sharing files and folders in the Help and Standards 8. Technical SpecificationsDiagnostic LED PortsTemperature DimensionsWeight HumidityTRENDware Technical Support E-mailAddress 9. Contacting Technical SupportTRENDware Technical Support over the Telephone Tel +1-310-891-1100 E-mail support@trendware.com