TRENDnet TEW653AP manual Power-over-Ethernet Installation, Using the TEW-653AP with a PoE switch

Page 5

ÐÓÑÑÊÈÉESPAÑOLDEUTSCHFRANÇAISENGLISH

3. Power-over-Ethernet Installation

Using the TEW-653AP with a PoE switch

1.Connect a RJ-45 cable from the Power-Over- Ethernet Switch (e.g. TRENDnet TPE-80WS) to the LAN port on the Access Point.

2.Verify that the wireless, LAN and power LEDs are on. Please refer to step 4 in the Hardware Installation section.

3

Image 5

Contents TEW-653AP Table of Contents System Requirements Package ContentsBefore You Start Hardware Installation Using the TEW-653AP with a PoE switch Power-over-Ethernet InstallationAdapter Using the TEW-653AP with the TPE-111GIClick Wizard Configure the Access PointClick Next Register Your Product Your configuration is completeMounting Windows XP/2000 TroubleshootingPage Assign your network a unique Ssid Wireless TipsDo not turn off the Ssid broadcast Change the channelPage Page GPL/LGPL General Information GPL/LGPL informações Gerais GPL/LGPL üldinformatsioon CertificationsProduct Warranty Registration