TRENDnet TEW653AP manual Hardware Installation

Page 4

2. Hardware Installation

Note: Locate an optimum location for the Access Point. The best place for the Access Point is usually at the center of your wireless network. Please connect the computer configuring the TEW-653AP to the same switch/hub.

1.Run a RJ-45 cable and the power adapter through the cable clip on the TEW-653AP.

2.Connect the RJ-45 cable from the Switch/Hub to the LAN port on the Access Point.

3.Connect the Power Adapter to the Access Point and then to a power outlet.

4.Verify that the wireless, LAN and power LEDs are on.

ÐÓÑÑÊÈÉESPAÑOLDEUTSCHFRANÇAISENGLISH

2

Page 3 Page 5
Image 4
Page 3 Page 5
Contents TEW-653AP Table of Contents Before You Start Package ContentsSystem Requirements Hardware Installation Power-over-Ethernet Installation Using the TEW-653AP with a PoE switchUsing the TEW-653AP with the TPE-111GI AdapterConfigure the Access Point Click WizardClick Next Your configuration is complete Register Your ProductMounting Troubleshooting Windows XP/2000Page Wireless Tips Assign your network a unique SsidDo not turn off the Ssid broadcast Change the channelPage Page GPL/LGPL General Information Certifications GPL/LGPL informações Gerais GPL/LGPL üldinformatsioonProduct Warranty Registration
Top Page Image Contents