Transition Networks |
Grounding the Industrial Switch
Wiring considerations
CAUTION
Be sure to disconnect the Industrial Switch from the DC power source before installing and wiring the device.
The following wiring considerations are recommended:
•Signal lines must not be directly connector to outdoor wiring.
•Use separate paths or conduits to route wiring for power and device data cables. To avoid interference, wires with different signal characteristics route separately. If power wiring and device data cables must cross make sure that the wires are perpendicular at the intersection point.
•Use the type of signal transmitted through a wire to determine which wires should be kept separate. The rule of thumb is wiring that shares similar electrical characteristics can be bundled together.
•Keep input and output wiring separated.
CAUTION
The Industrial Switch is intended to be grounded to a
Industrial Switch Grounding the Industrial Switch helps limit the effects of noise due to electromagnetic
groundinginterference (EMI) via proper grounding. Always run the ground connection from the ground screw to a grounding surface before connecting the Industrial Switch to a DC power source. See Figure 7.
Figure 7: Industrial Switch Ground Screw (Bottom Panel)
| 11 |