Transition Networks SISTF1010-150-LR(T) Advanced Features, Straight-Through and Crossover Cables

Page 27

SISTF1010-150-LR(T) Industrial Unmanaged Switch

Transition Networks

Advanced Features

AutoCrossTM

AutoCrossTM automatically detects and configures the twisted pair port on the converter to the

 

correct MDI or MDI-X configuration allowing either straight-through (MDI) or crossover (MDI-X)

 

cables to be used – see figure 15. No user intervention is required.

* Eliminates an entire category of troubleshooting

* No need to identify cable type; straight-through or crossover

* No user intervention required to determine correct button / switch settings

 

Figure 15: Straight-Through and Crossover Cables

 

 

Auto-Negotiation

Auto-Negotiation allows devices to perform automatic configuration to achieve the best

(IEEE 802.3u)

possible mode of operation over a link. The Industrial Switch will broadcast its speed

 

(10Mbps, 100Mbps) and duplex (half/full) capabilities to other devices and negotiate the best

 

mode of operation between the two devices.

 

* No user intervention required to determine best mode of operation

 

* Optimal link established automatically

 

* Quick and easy installation

 

Note: If the Industrial Switch is connected to a non-negotiating device over the copper link,

 

it will default to 10Mb/s speed, half duplex mode.

 

 

Pause

PAUSE signaling is an IEEE feature that is used to temporarily suspend data transmission

(IEEE 802.3xy)

between two devices in the event that one of the devices becomes overwhelmed. In the event

 

that a device needs some time to clear network congestion, it will send out a PAUSE signal to

 

the other end device, which will then wait a pre-determined amount of time before re-

 

transmitting the data. Transition's converters will pass PAUSE signaling unhindered; ensuring

 

that the message is delivered to the end device.

 

* PAUSE enabled devices allowed to work properly

 

* Prevents loss of valuable data transmission

 

* Reduces bottlenecks and allows for efficient use of network devices

 

 

24-Hour Technical Support: 1-800-260-1312 International: 00-1-952-941-7600

19

Image 27
Contents SISTF1010-150-LRT Installation ManualPage Table of Contents Transition Networks SISTF1010-150-LRT Trademark, copyright, and product classification information III About this product and manualOn next Transition Networks Section SISTF1010-150 Industrial Unmanaged Switch General description SISTF1010-150 Industrial Unmanaged Switch part numbers Package contents Physical description SISTF1010-150-LRT Industrial Switch Front ViewPhysical description Section Installation DIN rail mounting DIN rail mounting Wall mount Wall mountingGrounding the Industrial Switch Connecting power to the Industrial Switch Connecting power to the Industrial Switch Connecting power to the Industrial Switch Barrel Connector Interface Cable Connecting copper cables LNK/ACT Light Emitting Diodes LEDsSection Advanced Features Straight-Through and Crossover Cables Advanced FeaturesSection Cable Specifications Copper RJ-45 cable specifications Section TroubleshootingTroubleshooting problem and corrective action table Section Contact Us, Warranty Compliance Information Contact us Warranty Warranty Cuation Compliance informationSISTF1010-150-LRT Industrial Unmanaged Switch SISTF1010-150-LRT specifications, notices, and warnings Appendix a Technical SpecificationsSISTF1010-150-LRT specifications, notices, and warnings