Transition Networks SISTF1010-150-LR(T) installation manual Barrel Connector Interface Cable

Page 23

SISTF1010-150-LR(T) Industrial Unmanaged Switch

Transition Networks

Connecting power to the Industrial Switch, continued

Barrel connector A barrel connector interface cable is included with the Industrial Switch and can be used to

interface cable convert the barrel connector output of an external AC/DC power supply over to a wire interface that can then be inserted into the terminal block following the instructions and figure 9, both located on page 13 of this manual.

Note: An external AC/DC power supply is not included with the Industrial Switch. Transition Networks offers an accessory power supply that can be purchased separately, if required. Please see optional accessories in the general information section of this manual for ordering information.

CAUTION

The operating temperature of the Industrial Switch, when used in conjunction with an AC/DC power supply will be limited to the lesser operating temperature range of either device.

For example: SISTF1010-150-LRT (-40ºC to +75ºC operating temp) used with SPS-UA12DHT-xx (-25ºC to +70ºC operating temp)

Operating temp for combination is -25ºC to +70ºC

Step

Action

1.

Locate the barrel interface cable included in the Industrial Switch packaging.

2.

Strip the power wires as required.

3.

Insert one stripped power wire into the terminal block plug, Observe polarity. See

 

Figure 9 on page 13.

4.

Secure the wire using a flathead screwdriver by tightening the contact screw.

 

See Figure 9 on page 13.

5.

Repeat Steps 3 and 4 until all wires are installed and secured.

6.

Locate an external AC/DC power supply with barrel connector interface and

 

make sure the power supply is not plugged into any power source.

7.

Insert barrel connector into the receptacle on the interface cable. See Figure 11.

External AC/DC power supply with barrel connector

Barrel Connector

Interface Cable

Figure 11: Barrel Connector Interface Cable with external power supply

Step

Action

8.Plug external AC/DC power supply into an external power source.

9.Turn ON or plug in the external power supply and the PWR LED should turn ON along with PWR 1 LED and/or PWR 2 LED, depending on whether one or both power supplies are connected and turned ON.

24-Hour Technical Support: 1-800-260-1312 International: 00-1-952-941-7600

15

Image 23
Contents SISTF1010-150-LRT Installation ManualPage Table of Contents Transition Networks SISTF1010-150-LRT Trademark, copyright, and product classification information III About this product and manualOn next Transition Networks Section SISTF1010-150 Industrial Unmanaged Switch General description SISTF1010-150 Industrial Unmanaged Switch part numbers Package contents Physical description SISTF1010-150-LRT Industrial Switch Front ViewPhysical description Section Installation DIN rail mounting DIN rail mounting Wall mount Wall mountingGrounding the Industrial Switch Connecting power to the Industrial Switch Connecting power to the Industrial Switch Connecting power to the Industrial Switch Barrel Connector Interface Cable Connecting copper cables LNK/ACT Light Emitting Diodes LEDsSection Advanced Features Straight-Through and Crossover Cables Advanced FeaturesSection Cable Specifications Copper RJ-45 cable specifications Section TroubleshootingTroubleshooting problem and corrective action table Section Contact Us, Warranty Compliance Information Contact us Warranty Warranty Cuation Compliance informationSISTF1010-150-LRT Industrial Unmanaged Switch SISTF1010-150-LRT specifications, notices, and warnings Appendix a Technical SpecificationsSISTF1010-150-LRT specifications, notices, and warnings