User’s Guide

CSEFE10xx-10x

Slide-in-Module Media Converter

•Switchable Ethernet and Fast Ethernet

•10 Mb/s Copper to Fiber

•100 Mb/s Copper to Fiber

Transition Networks CSEFE10xx-10x series Ethernet / Fast Ethernet media converter is designed to be installed in a Transition Networks PointSystem™ chassis and is a 10Mbps or 100Mbps switch-selectable media converter.

Both the copper and fiber links operate at the same speed setting via a hard set with a dip switch, so the media converter operates at either 10 Mb/s copper to fiber or 100 Mb/s copper to fiber.

Part Number	Port One - Twisted-Pair	Port Two - Fiber Optic
	Copper

CSEFE1012-100	RJ-45, 100 m (328 ft)*	ST, 1310 nm single mode
		duplex fiber, 20 km (12.4 miles)*

CSEFE1014-100	RJ-45, 100 m (328 ft)*	SC, 1310 nm single mode
		duplex fiber, 20 km (12.4 miles)*

CSEFE1015-100	RJ-45, 100 m (328 ft)*	SC, 1310 nm single mode
		duplex fiber, 40 km (24.8 miles)*

CSEFE1022-100	RJ-45, 100 m (328 ft)*	ST, 1310 nm single mode
		duplex fiber, 40 km (24.8 miles)*

CSEFE1029-100	RJ-45, 100 m (328 ft)*	SC, 1310 mn (TX)/1550 nm (RX)
		single fiber, 20 km (12.4 miles)*

CSEFE1029-101	RJ-45, 100 m (328 ft)*	SC, 1550 mn (TX)/1310 nm (RX)
		single fiber, 20 km (12.4 miles)*

The CSEFE10xx-10x media converter is designed to be installed in pairs, where one is the local media converter and the other is the remote. For example, a local CSEFE1011-100 converter is connected, via fiber, to a remote CSEFE1011-100 converter.

For a single fiber network, a local CSEFE1029-100is connected, via fiber, to a remote CSEFE1029-101converter.

* Typical maximum cable distance.	Installation	.2
Actual distance is dependent upon the	Operation	.5
physical characteristics of the network.	Cable Specifications	.6
(TX) = transmit, (RX) = receive	Technical Specifications	.8
	Troubleshooting	.9
	Compliance Information	12